Discuss Leaky shower pipe after repair in the Plumbing Jobs | The Job-board area at PlumbersForums.net

Status
Not open for further replies.
P

pennines

Hi, I am covered with British Gas homecare so called them out to a rumbling when hot taps were on, they changed the washer in the downstairs taps and replaced the tap. A day later rumbling started again when tap upstairs was on and downstairs tap, all the while a drip at the back of the shower tap had been getting worse, going from a drip to a trickle, they came back and replaced the upstairs washers, rumblings stopped and drip stopped...for a day...rumbling has stopped but the drip started again going from about five a minute to twenty a minute. Worse when central heating is on. Is this air or does the tap need tightening? I don't want it to be some sort of release and then leaks elsewhere it can cause damage as currently it's leaking in the bath. Thanks! P1110351.jpgP1110351.jpg
 
Tighten the nut up a bit

Hi, thanks for the reply
can you tell me why it stopped leaking on the first day he fixed it please and yet started again? if the nut was tight enough to suppress the leak for 24 hours then started leaking, do they come loose on their own, will it need a new nut? Thanks
 
Who knows?!! I don't. Waters a funny thing. One day all tickety boo the next you're swimming in it.



Which is why I would like advice before calling them back...I don't want to take the risk of him tightening it up and it start leaking down the back instead and the kitchen below swimming in it. Had that problem once before, three plumbers scratching their heads over a leaky tap in my old house and never did find the problem, hence joining the homecare - so far same problem. :D
 
Is it possible it's already over tightened? Olive squeezed the pipe a little too much? Undo and wrap a little PTFE tape around the olive to seal could be the simple answer.
 
You pay enough for the cover, get them out to fix it properly. The drip is 1 fault the noise may be another!
 
If he fitted a fibre washer it just needs a squeeze, or it was to tight and it's split. Easy to check.
Ps lots of calcium around your shower bar, make life easy and fittings last longer and fit a water softener
 
Last edited by a moderator:
Status
Not open for further replies.

Reply to Leaky shower pipe after repair in the Plumbing Jobs | The Job-board area at PlumbersForums.net

Similar plumbing topics

Hi everyone, I recently had a Hansgrohe wall mounted single lever basin tap and a Hansgrohe thermostatic concealed bath/shower valve installed...
Replies
3
Views
918
Hi all I really need some help or advise….. Back story….. Some years ago my dad had an extension to his house which included a newly built...
Replies
2
Views
373
J
    • Like
I have an Arteform shower valve in my bathroom - top lever for the main shower head, middle for the handheld hose and bottom is the thermostatic...
Replies
1
Views
427
Hi I've recently had a new bathroom installed. I've noticed when I flush the downstairs loo there was a hammer type noise under the bathroom...
Replies
6
Views
828
Hi, as you can see pictured I have a stopcock without a packing gland. Over the past few days my cistern inlet was suffering from an airlock and...
Replies
6
Views
557
Back
Top