Discuss Height of an Air Admittance Valve in a bathroom in the Plumbing Jobs | The Job-board area at PlumbersForums.net

Building regs Chris - my interpretation is if you have a sewerage back up you may not notice a boxed low fitted air addmitance valve leaking but a overspill from the toilet or basin will show immediately the valves should be visable and removable for maintenance above the spill over level for rodding access if its needed whether we agree or not we should all be fitting to the regulations . Cheers kop
Totally agree kop with the pan but does not need to be above the basin, on this one.
1. Water finds its own level so if the stack blocked & you were silly enough to carry on using the basin it would over still the pan.
2. OP has fitted an anti-syphon trap to the basin which is below the overspill of the basin which is one of the reasons I don't like them.
 
I just don't understand where all this requirement for costly waterless & anti-vac traps is coming from? :(
If this stub is on the ground floor it doesn't need the Durgo.

Actually, that’s not quite true. The idea of the AAV is to prevent either negative or positive pre
Why ?
If it blocks the water will overspill the Pan not the basin.

Not if it’s on the ground floor and vermin control flaps have been or anti flood valves.
Maybe the requirement is a ‘ one fit for all’ type.
 
Actually, that’s not quite true. The idea of the AAV is to prevent either negative or positive pre
I don't think you quite understand how a Durgo works they can only prevent negative pressures by opening to allow air in. They can't no positive otherwise the foul smells would come out.
Not if it’s on the ground floor and vermin control flaps have been or anti flood valves.
Maybe the requirement is a ‘ one fit for all’ type.
If it is a stub stack (i.e. on the ground floor) it wouldn't need one anyway (unless the drain was deep)
Sorry don't understand
"Maybe the requirement is a ‘ one fit for all’ type" can you explain ?
 
Totally agree kop with the pan but does not need to be above the basin, on this one.
1. Water finds its own level so if the stack blocked & you were silly enough to carry on using the basin it would over still the pan.
2. OP has fitted an anti-syphon trap to the basin which is below the overspill of the basin which is one of the reasons I don't like them.
On point 1. It depends where the blockage is. If the pipe blocks between toilet and basin, the basin will overflow
 

Reply to Height of an Air Admittance Valve in a bathroom in the Plumbing Jobs | The Job-board area at PlumbersForums.net

Similar plumbing topics

In the photo there is a grey 32mm push fit elbow between the sink trap and down pipe. I want to replace the elbow with a "male" push fit tee...
Replies
6
Views
323
The soil pipe from my bathroom passes through the outside wall and into the roofspace above the adjacent single storey kitchen before dropping...
Replies
4
Views
145
Hi, We're in the process of upgrading 2 bathrooms in our house: the ensuite and the family bathroom. These adjoin one another. The ensuite is...
Replies
3
Views
70
Hi all, grateful for your expertise on the following. DIYer, not pro. Rural property in France Single storey. Septic tank. Late 80s construction...
Replies
1
Views
225
Hi, Can anyone advise as to why the cold water to my bathroom keeps airlocking? This originally happened about 12 months ago and has happened 3-4...
Replies
9
Views
461
Back
Top
AdBlock Detected

We get it, advertisements are annoying!

Sure, ad-blocking software does a great job at blocking ads, but it also blocks useful features of our website. For the best site experience please disable your AdBlocker.

I've Disabled AdBlock