Discuss Doc m handle i.d. in the USA area at PlumbersForums.net

WC1

Esteemed
Plumber
Gas Engineer
Messages
1,253
It's the lever I need - it's got an extra long threaded section and came with 2 X wedge shaped washers to take up the curve of the cistern wall. Thanks
 

Attachments

  • 20210907_155748.jpg
    20210907_155748.jpg
    207 KB · Views: 16
This is the one you have but look discontinued

Amazon /Square-Cistern-Paddle-Handle-Disabled/dp/B019IQ0UME
 

Reply to Doc m handle i.d. in the USA area at PlumbersForums.net

Similar plumbing topics

I was stupid enough not to check the position of the pipes under the tiles when installing a toilet and drilled right through the center of a 16...
Replies
0
Views
240
S
Hi, I seemed to have a blockage in kitchen sink. A plumber came and cleared all the pipework that is visible inside my home (there was debris and...
Replies
2
Views
162
Sonya K
S
Hi, basic question, any insight much appreciated. Looking to have an outdoor tap in my front porch fed from 15mm pex coming up from suspended...
Replies
6
Views
304
Can anyone recommend a decent multi meter, preferably under a 100 pounds. It's for checking boiler components so I don't need a top spec one...
Replies
7
Views
306
The left rear floor corner is highest (the shower pan touches/sits on the floor), sloping down diagonally to the front right corner (lowest). The...
Replies
6
Views
274
Back
Top