Discuss Covered in confusion - mains gas pipe diameter in the UK Plumbing Forum | Plumbing Advice area at PlumbersForums.net

Messages
3
Hi
Having lived in a new build for 14 years, on trying to replace our two boilers I’ve been told the installation is dangerous (and has always been so and one boiler has been shut down. The diameter of the pipe from the mains (on one side of the house, which runs under the floor to the boilers on the other side of the house) is too narrow and must be rerun which involves taking up paving and digging a trench plus the run may be too long to be effective. It’s been non compliant and dangerous since installation apparently. I still have the original gas safety certificate sign off, my question is can I go back to the original plumber who installed and signed this off after all this time as it has been unsafe to rectify?
 
I would get an independent engineer to conduct a pressure drop test with all gas appliances running
 
As Shaun has said, get an independant engineer /small local company to test then also get them to quote for new boiler(s).

I would imagine B.G are just quoting like for like, in rating, for new boilers.
What it needs is a complete assessment of the heat loss for the house and then determine the size of boiler(s) required.
It may be that the total boiler rating can be reduced enough to be able to use the existing pipework.

Alternately the local company may find aa acceptable route for a new pipe that doesn't involve digging.

The existing pipework may have been non compliant but cannot have been dangerous otherwise every time British Gas, with all their experience, knowledge, trained engineers etc, have serviced the boilers and left them working they have been guilty of leaving the installation in a "Dangerous" state.

If it definitely is/ has been Dangerous, then I'd be looking at least to get BG to refund what they've charged for over the years as by their own admission they've left it in that state several times.
 

Reply to Covered in confusion - mains gas pipe diameter in the UK Plumbing Forum | Plumbing Advice area at PlumbersForums.net

Similar plumbing topics

We run a community village hall and have a large kitchen provided for the use of hirers. This includes a Lincat SLR9 gas cooker which I believe is...
Replies
5
Views
562
Hello all, I’m replacing a concrete paving slab patio in the back yard. The original patio used 50mm deep concrete slabs on hardcore & sand. I’m...
Replies
6
Views
326
We are from Alberta, and I own an electrical company. I have been asked by a BC Mechanical P. Eng. to install an emergency STOP button at the...
Replies
5
Views
333
Hello all, I'm would like to extend an existing outside tap to another point in the garden. I'm about to pour a concrete patio and was hoping to...
Replies
6
Views
293
Hi, Can anyone advise as to why the cold water to my bathroom keeps airlocking? This originally happened about 12 months ago and has happened 3-4...
Replies
9
Views
465
Back
Top
AdBlock Detected

We get it, advertisements are annoying!

Sure, ad-blocking software does a great job at blocking ads, but it also blocks useful features of our website. For the best site experience please disable your AdBlocker.

I've Disabled AdBlock