Search the forum,

Bramham stuck tap head

Post new thread

Discuss Bramham stuck tap head in the UK Plumbing Forum | Plumbing Advice area at PlumbersForums.net

P

Paul Wilkinson

Messages
1
Hi, i have a dripping hot tap on Bramham mono sink basin. I’ve replaced washer several times and can’t remove the tap head to deal with the cartridge. It is a screw cap cover but no additional screw underneath to release tap head. Thankyou
54F6118E-74CA-416D-8BCC-FBBF0D654BE4.jpeg
BDDBC1F9-F954-4763-97D8-40AFA74348F9.jpeg
 

Reply to Bramham stuck tap head in the UK Plumbing Forum | Plumbing Advice area at PlumbersForums.net

Similar plumbing topics

B
Brass tap body is leaking.
I have attached an image of the brass body within a tap. Having replaced a cartridge which has cured a leaking tap, I can see that there is a small leak from the brass body which can be unscrewed. Is there a seal behind the body? Thanks.
Replies
2
Views
297
Bp89
B
R
squeaky grohe bathroom tap 2 months old
Hi bit of a weird issue, I installed a grohe bathroom tap successfully 2 months ago bought from screwfix. Last week the right hand hot tap makes a squeak noise as I turn it on or off, left tap is 100% perfect and noiseless. This grohe tap is like one unit, so no screw notch or way I can remove...
Replies
1
Views
95
Lou
Lou
D
UK Can't get stopcock 100% closed to allow a tap repair
I have a plumber coming tomorrow to change a cartridge on a badly dripping tap on my bathroom mixer unit. There is no separate isolating valve for this tap so I'll have to close the stopcock. I tried closing it today but it won't go absolutely 100% closed and there is still a very slight flow...
Replies
1
Views
236
Chuck
C
S
Advice needed for a mixer Spray for kitchen ?
Hello plumbers in my internet. So the Mrs want a spray mixer tap in the kitchen as we had two separate taps. I changed the tap for a temporary two hole mixer but the cold water pressure is high mains fed and the hot is low pressure immersion tank fed. I've been trying to find info on what I...
Replies
2
Views
119
Lou
Lou
M
Central heating losing pressure all the time
Every two weeks or so I have to go and top up the system because the hot taps are running cold. Boiler display is flashing 0.6 bar and I fill up to 1.3. I've had an engineer look inside the boiler and he can't see anything wrong. I've checked the pipes all over the house and cannot see any...
Replies
1
Views
137
fowlerboi
F
Creating content since 2001. Untold Media.

Newest Plumbing Threads

Tiling Forum UK
British Standards in Tiling BS5389
Tiling Forum UK
Electrician Talk Forum
Contractor Advice Forum
Back
Top
AdBlock Detected

We get it, advertisements are annoying!

Sure, ad-blocking software does a great job at blocking ads, but it also blocks useful features of our website. For the best site experience please disable your AdBlocker.

I've Disabled AdBlock