Boulter Camray 5 oil combi loss of hot water???

[boulter]

It's a Boulter Camray 5 oil burning combi.
When heating is on shower and bath are piping hot.
When you shower during the day when no heating on it runs cold after a minute.

The pipes to the DHW storage tank feel hot but it's as if this tank isn't full before showering so runs cold quickly.
Where does this tank get a signal from to keep hot during the day?
Is the tank stat just for the cutout temp or cut in as well?

Tank stat works ok when heating is on as tank is hot and full then.
Presume flow switch is ok as DHW is supplied when shower is turned on(when heating on)
Think 3 way valve is ok for the same reason and heating is fine.

The programmer is a sunvic TLX rfp with a remote programmable room thermostat.

The 15mm water supply pipe to storage tank ,before flow switch, is half open, should this be full open?

Thanks for any help

 

[lance]

15mm pipe should be fully open.

Have you vented tank?

 

[ecowarm]

As above isolation valve sould be fully open, and during h/w only use is the boiler/Programmer set to H/W on

 

[kimbo]

You need to check that when hot water is on and the hot tap is open that you have a live supply in and out of the flow switch, then check to see if you have a live supply to the pump, you only get how water when the heating is on because the pump is already running for the heating and it is also circulating the hot around the heat exchanger. I suspect that there is no hot only because either the pump is not activated by the flow switch or the diverter valve is partially stuck.The boottom lever on the diverter valve should be fully over to the left when you look at it for hot water only.

 

[boulter]

Tommorow will try venting,opening supply valve fully,check diverter is fully over and test flow switch.
Thought the flow switch was ok as when I open a tap the flow LED comes on and I do get full flow when the heating is on, the same reasons for presuming the 3 way valve was ok too.
Thanks for the helpful replies.

 

[pauly]

hi i have problems with my flow switch too. can you tell me can i link it out to see if that's what causing my lack of hot water? also do i need to drain down the system to replace the flow switch as when i loosened it with all the valves shut water came out under pressure. Also the red lock out indicator is on. how do i sort this please.

 

[lame plumber]

hi i have problems with my flow switch too. can you tell me can i link it out to see if that's what causing my lack of hot water? also do i need to drain down the system to replace the flow switch as when i loosened it with all the valves shut water came out under pressure. Also the red lock out indicator is on. how do i sort this please.

your better off getting an engineer in as you dont seem to have a clue on this one at all omho

 

[pauly]

your better off getting an engineer in as you dont seem to have a clue on this one at all omho

thanks for your help. (not)

 

[lame plumber]

from what you said your knowledge seems very limited so offering advice will only make things worse aparft from saying you need to look at it step by step to see why its locking out. Also if you dont understand about isolating and depresssurising a system to remove parts the less said the better. Personally oil and soild fuel can be equally as dangerous as gas but not enough of you have killed yourselves recently for the government to do anything about it yet.

 

[Rickster123]

thanks for your help. (not)

You have been offered good advice. Please rethink your plans of a DIY repair on something you clearly have little knowledge of.