Discuss baxi genesis in the Plumbing Jobs | The Job-board area at PlumbersForums.net

Status
Not open for further replies.
C

cod

The boiler delivers hot water and central heating, but the pump runs on continuously after hot water demand ceases (the boiler is in water only mode)
 
Last edited by a moderator:
Cod,
Did you solve this problem - I have the same issue with a Baxi Genesis 80 but it only happens when switched to HW/CH, its ok when in HW only. Cheers

John
 
You require a gas safe engineer. This forum no longer provides boiler repair advice on the open forum.
 
Status
Not open for further replies.

Reply to baxi genesis in the Plumbing Jobs | The Job-board area at PlumbersForums.net

Similar plumbing topics

  • Question
Ideal Logic 24, Previous problem was that the hot water was only cold or barely warm if the heating was in use. If heating was off and boiler cold...
Replies
2
Views
226
Every two weeks or so I have to go and top up the system because the hot taps are running cold. Boiler display is flashing 0.6 bar and I fill up...
Replies
2
Views
287
PSxxxxxx
P
Hi everyone, Looking for a bit of advice, recently went to a job where heating was operating when called for however not for the hot water. I...
Replies
8
Views
399
Hello, I am seeking some advice, I have a POTTERTON PROMAX 28 COMBI Boiler and I noticed yesterday that the water around the house is no longer...
Replies
4
Views
291
Hi all. Hope you have all been keeping well. A while back I decided I only wanted to fit one brand of boiler and decided on Viessmann due to...
Replies
9
Views
328
Back
Top
AdBlock Detected

We get it, advertisements are annoying!

Sure, ad-blocking software does a great job at blocking ads, but it also blocks useful features of our website. For the best site experience please disable your AdBlocker.

I've Disabled AdBlock