Search the forum,

Discuss Air Admittance Valve Problem? in the UK Plumbing Forum | Plumbing Advice area at PlumbersForums.net

S

Steve F

Water nearly rises to top of pan when flushing toilet then very slowly lowers. Tried several attempts to clear any blockages, hasn’t made any difference. Would a faulty Air Admittance Valve (stuck in shut position) prevent the normal emptying when flushing?
 
If you can get to the AAV take it off and see if toilet flushes normally.
Sometimes there is a partial blockage in the soilpipe which is made more obvious because of a stuck AAV not letting air out.
If there are basins, baths, etc connected to your soilpipe do they drain OK?
 
If you can get to the AAV take it off and see if toilet flushes normally.
Sometimes there is a partial blockage in the soilpipe which is made more obvious because of a stuck AAV not letting air out.
If there are basins, baths, etc connected to your soilpipe do they drain OK?
Haven’t noticed any problems with sink or shower. Can’t get at AAV as it was boxed in during refurbishment.
 
Again, if you can remove the AAV and cover the pipe with cling film and it rises when the toilet is flushed then the problem is downstream of the toilet, or lift the outside manhole cover and see how quickly water flows out.
 

Reply to Air Admittance Valve Problem? in the UK Plumbing Forum | Plumbing Advice area at PlumbersForums.net

Similar plumbing topics

Hi, Can anyone advise as to why the cold water to my bathroom keeps airlocking? This originally happened about 12 months ago and has happened 3-4 times since. It’s an upstairs bathroom, fed from a tank in the attic. The tank is about 8 Meters away and feeds a bath, sink and toilet. The tank...
Replies
9
Views
339
Our kitchen mixer tap has started dripping. Like so much of the plumbing in our almost new build bungalow, it is lacking! The plumber didn't install any isolating cocks in the H&C feed to the tap so how can I identify which of the valves is passing? Shut the whole H&C water system down?
Replies
12
Views
339
Hi. I need a new toilet supply line but don’t know the size type of the fitting at the shut off valve. It is not 3/8 compression. It is a plastic nut about the same size as the one going into the cistern but has a different thread. Attached is a photo. Can you advise. Thanks.
Replies
2
Views
189
Hi all I'm hoping someone can shine a light on this for me Since our stop tap on the pavement has now been filled with sand for whatever reason, we are relying on our property fitted stopcock (this is outside on our garage wall) Unfortunately turning this to the closed position only reduces...
Replies
3
Views
252
Creating content since 2001. Untold Media.

Newest Plumbing Threads

Back
Top
AdBlock Detected

We get it, advertisements are annoying!

Sure, ad-blocking software does a great job at blocking ads, but it also blocks useful features of our website. For the best site experience please disable your AdBlocker.

I've Disabled AdBlock