Discuss 15mm Gas supply in the Plumbing Jobs | The Job-board area at PlumbersForums.net

Status
Not open for further replies.
S

sgw869

Hello
I live in Spain and at last we are have gas piped to our urbanization
Question is from the underground supply the installer has run 15mm copper supply pipe
The pipe work has approx 12 soldered bends and the run is approx 10-12 metres
This pipe is supposed to feed four properties
When the pipe reached the central point of the four properties it splits four ways and I can only assume that is where the meters will go.
I am contemplating a 24kw combi boiler, my question is will the 15mm supply pipe be adequate to run one boiler, let alone four in total
Also there is the gas ovens and hobs to add to the equation
I can supply photographs if this would help
Best regards
Sgw
 
it depends what preasure they supply the gas at as to the pipe size im sure there was some one on here who has worked in spain
 
Depends on the pressure. It is usually higher on the inlet to the meter and governed down to working pressure from there.
Best speaking to the guys doing the work.
 
Sounds like you need to get in the pro's, bet the gsr doesnt cover Spain lol
 
It's probably LPG and they may install regulators at he property.
 
Aint got the slightest. Never heard of it 15mm feed upstream to feed four meters and then more appliances I'm loast.
 
Aint got the slightest. Never heard of it 15mm feed upstream to feed four meters and then more appliances I'm loast.

I'll put my money on it being from a comunal lpg bulk store, supply from it medium pressure to the meters and goveners to knock it back down to low pressure.

will have to be a flipping big bulk store for the vapour take off rate to be high enough though?
 
Going back to the original post.

If I lived in Spain I would have solar thermal, with electrical back up ?

Why a combi ?

The suppliers will be supplying gas for cooking/gas fire only ?

Different regs I am sure.

Bearing in mind the country is nearly bankrupt I doubt they are forward planning too much !
 
Status
Not open for further replies.

Reply to 15mm Gas supply in the Plumbing Jobs | The Job-board area at PlumbersForums.net

Similar plumbing topics

Im fitting a kitchen in my own house . When removing the gas oven on a bayonet fitting and turned the gas hob off and removed a four burner gas...
Replies
5
Views
582
Hi All, I need your advise as I'm really concerned here. I only just had regular boiler replaced with combi (Vaillant ecoFIT Pure 25kw). I had few...
Replies
10
Views
2K
Hi, I am a homeowner but caught between a rock & a hard place. I am trying to get a Vaillant ecoTEC 630 plus serviced but the gas safe engineer &...
Replies
8
Views
2K
  • Question
As part of our house refurb I had the boiler replaced and a pressurised hot water cylinder fitted. Builder's CH people used Glowworm Energy 7 30S...
Replies
25
Views
4K
So we are looking at a new vaillant ecofit pure 418 regular boiler but have a question about the gas pipe size requirements.. At the gas meter...
Replies
6
Views
4K
Back
Top
AdBlock Detected

We get it, advertisements are annoying!

Sure, ad-blocking software does a great job at blocking ads, but it also blocks useful features of our website. For the best site experience please disable your AdBlocker.

I've Disabled AdBlock