- Messages
- 34,374
- Solutions
- 2
Don't have a clue mate
Discuss HALL of SHAME PHOTo`s in the Plumbing Jobs | The Job-board area at PlumbersForums.net
- Status
Don't have a clue mate
- Messages
- 10,444
- Messages
- 34,374
- Solutions
- 2
It's not that bad only took me an hour and yes I ran out of lagging
- Messages
- 34,374
- Solutions
- 2
I spy with my eye
- Messages
- 10,444
Nice easy job mate. It will only take you 5 minutes.
- Status
Reply to HALL of SHAME PHOTo`s in the Plumbing Jobs | The Job-board area at PlumbersForums.net
Similar plumbing topics
Good afternoon all,
First time posting on this site.
I’m need of some opinions from Gas engineers if possible.
My house is 1930s (I think). I...
Good Afternoon all,
I am hopeful someone may be able to offer some guidance on the following.
In the home we have a gas boiler (serviced...
This issue arose about a year ago. Does anyone have an idea why I occasionally hear (about once every hour or longer) a hammer related noise...
My living room smells like a sewer but I can't tell where it is coming from. Not sure where to start looking. The saniflo discharge pipe runs...
We have an all Vaillant setup - an EcoTEC Plus 637 system boiler plus wired VR720 and VR92 SensoCOMFORT controller, driving two CH zones plus DHW...
Newest Plumbing Threads
-
How much would you pay for a universal flush valve that enables replacements in under 5 minutes?
- Started by Professor
- Replies: 6
-
Bossing shower waste into soil pipe vs. separate shower waste- Started by CitizenErased
- Replies: 3
-
UK Advice on waste water pump in first floor flat
- Started by kbqwert
- Replies: 2
-
AM18x1 femail to 1/2" hose connector.
- Started by Adaminspace
- Replies: 0
-
Off grid shower and toilet solution needed
- Started by TpXThinnr
- Replies: 4
-
Expansion vessel size unvented hot water
- Started by Matt0029
- Replies: 2
-
Acrylic bath manufacturing standards/dimensions
- Started by Michelle
- Replies: 2