Discuss Regs/good practise on thickness of pipe lagging? in the Plumbing Jobs | The Job-board area at PlumbersForums.net

Status
Not open for further replies.

WaterTight

Esteemed
Plumber
Subscribed
Messages
5,439
Haven't bought any for ages cos I inherited a tonne of it. Went to get some today and my merchant was offering four thicknesses for 15mm. I said it was going under floorboards on ground floor and so he recommended 19mm. I think they were 9mm, 13mm, 19mm and 25mm. What circumstances are these thickness for and are there regs on this?
 
the thicker the lagging the more protection from freezing there are regs covering external use it must be water proof as normal stuff will rot
 
I thought the difference was thicker the lagging the bigger the profit for the merchant,coz every time I get the thick stuff they seem really happy charging me a fortune and when I say just thin ,cheap stuff will do ,they look all sad and loose interest in sale :icon9:
 
Only regs I have heard is the insulation most be at least the thickness of the pipe, but usually only 19 mm is used by most people. If it's new build work then no excuse - it should be heavy, but if you are on 2nd hand work where pipes are too tight together, then 9mm might be best you can do. Pipes outside or unheated areas like a garage, are the important areas.
 
i have only seen different levels quoted in contracts we did for councils who quoted "lagging to protect to -??degree C" and then they specified what he had to use, but there must be something in a BS somewhere (i think BS6700 is a water reg)
 
Should be 19mm min on 22mm pipe and 25mm thick on 15mm to offer the same level of protection. It is to do with the volume of water in the pipe.
Just because it is for sale doesn't mean you can legally use it but some is better than none i suppose.
 
Should be 19mm min on 22mm pipe and 25mm thick on 15mm to offer the same level of protection. It is to do with the volume of water in the pipe.
Just because it is for sale doesn't mean you can legally use it but some is better than none i suppose.
Never heard that before, Tamz. I assumed volume of water didn't really matter.
 
As 15mm tube has less volume of water it also has less relative heat energy so will cool quicker.
 
Thanks Tamz. Never thought of it that way. Suppose that's just the same as a thin film water freezing quicker in winter than a heavier amount.
 
Status
Not open for further replies.

Reply to Regs/good practise on thickness of pipe lagging? in the Plumbing Jobs | The Job-board area at PlumbersForums.net

Similar plumbing topics

Hi, I've only just registered on this forum and hope there is someone out there that can help. I've just dismantled an old kitchen in our house...
Replies
17
Views
10K
S
  • Locked
Over a year ago a good local plumber installed for me (the householder) a new Grant Vortex Eco Utility 26 35 boiler, but ended the job (for which...
Replies
12
Views
4K
lame plumber
L
  • Locked
Hi all, Bit heavy for a Friday night but here goes... Around 6 months ago we acquired a customer through Checkatrade. Very large heating...
Replies
25
Views
433
newcastle phill
N
D
  • Locked
I’m sorry this is long but I need to lay down the facts. I’ve been in my house for 30 years. Prior to my ownership land to the side of the house...
Replies
17
Views
2K
Dotty
D
N
  • Locked
None of the pipework in my loft to/from my unvented cylinder has been lagged. I am looking to buy and fit the lagging myself. Some queries: 1...
Replies
13
Views
5K
markproperjob
M
Back
Top