Stick to what you know best

[Steve weightman]

Have a landlord and appliance shop owner who I fit cookers and hobs etc for who's currently turning old shops into a couple of flats. I've put in the cylinder and tanks and new cold water mains but was not asked to fit the bathrooms which I couldn't understand. He wanted the so called builder to do it and for me to commission it only because he's paying him peanuts for the building work so getting the bathroom installation cheap. So I dropped in to check it and I compare it to going into an exam room to spot all the faults which I lost count of. Kitchen taps on the bath and basin,bath won't go in the corner due to the waste pipe against the legs,bath trap elbowed up to the waste pipe leaving 6 inches of water in the bath,all compresion fittings with tape around the threads lol and from the 22mm I left from the hot water draw off reduced down to 15mm again on a compression fitting.ended up taking it all out and starting again.

 

[LGriffiths]

 

[Aire]

The waste pipe is shocking but the taps look fantastic

 

[DXCross]

Builders build plumbers plumb springs to mind..

I chuckled at the bath ‘taps’

 

[Steve weightman]

Builders build plumbers plumb springs to mind..

I chuckled at the bath ‘taps’

I did at least there on the sink must have had a job lot on pillar taps that day

 

[Steve weightman]

The waste pipe is shocking but the taps look fantastic

Yeah one for the books.. I thought it was a inline trap lol

 

[Harvest Fields]

Looks ok from my house. Apart from the gap around the bath that is

 

[townfanjon]

Well , thats just absolute quality !!!

 

[Burger]

I hope you charged him extra for putting right someone else’s shoite?

 

[Burger]

Can’t say the taps haven’t got a minimum air gap