Vokera Linea 24 wireless Therm

[timmy1875]

Hi all im trying to fit a wireless thermostate to my boiler but not sure which wires to remove and which ones to connect to the reciver. I have includesome pics below pic 1 is the wiring dig for the boiler, pic 2 is the actual block in the boiler and pic 3 is the back of the reciver. Can anyone help.

 

[Billy Bob Bob]

yes get a gsr engineer in or sparky,you stick wires in the wrong place and you will blow the board or yourself

 

[timmy1875]

I guess you are one of these so can you help me out by advising what goes where.

Cheers
T

 

[Billy Bob Bob]

yes i am looking at those photos you have bought a salus/tower stat do your self a favor,bin it and buy a honeywell salus are extremely unreliable

 

[timmy1875]

You seem to know your stuff so can you please advise me on how to wire it?

 

[Billy Bob Bob]

can you use/own a multi meter?

 

[timmy1875]

i own one yes

 

[timmy1875]

this is the diagram from the boilers book

 

[Billy Bob Bob]

well the 2 terminals with a link in marked poss could be your control wires but i dont know your boiler so not sure,would need to see mi,s as your control wires could be mains or low voltage in which case you would remove the link from the salus,plus you need to take mains into the salus use your meter

 

[timmy1875]

http://vokera.co.uk/wp-content/uplo...8_installation_and_servicing_instructions.pdf

This is my boiler, ive come to the conclusion that i need to link the "=" wire to the hole marked com on the receiver not sure which 1 the TA wire coes to, either NC or NO on the receiver. ive taken the link out.