Search the forum,

Thermostatic shower valve replacement

Post new thread

Discuss Thermostatic shower valve replacement in the DIY Plumbing Forum area at PlumbersForums.net

R

RobKillalea

Messages
1
Hi DIYer here. Trying to replace concealed shower thermostatic valve. Please could you advise on how to remove valve. Very large box spanner? Many thanks
IMG_20230606_202015.jpg
 
Sort by date Sort by votes
Put a large slotted screwdriver in the left hand slot and strike it downwards with a hammer using short sharp blows. You have to have the screwdriver almost vertical, resting on the bottom ledge of the slot.
 
Upvote 0 Downvote

Reply to Thermostatic shower valve replacement in the DIY Plumbing Forum area at PlumbersForums.net

Similar plumbing topics

C
Mixer bar fitting solutions?
The fittings below are for a mixer bar attached to a self contained shower. i.e not a wall. The attaching screws have snapped. I could get two new brackets, dismantle that existing one and start again or I could try and re attach via those screws, removing the broken ones from the plate and wall...
Replies
1
Views
201
SimonG
SimonG
S
Advice needed for a mixer Spray for kitchen ?
Hello plumbers in my internet. So the Mrs want a spray mixer tap in the kitchen as we had two separate taps. I changed the tap for a temporary two hole mixer but the cold water pressure is high mains fed and the hot is low pressure immersion tank fed. I've been trying to find info on what I...
Replies
2
Views
137
Lou
Lou
N
Towel Rail Valve Advice please (35 Characters needed.)
I have had a look at previous posts and think I know the answer to this but just before I make it worse could I just check what you think about this one. Granddaughter just moved house and this valve decided to leak when it was closed. When open its fine. Normally I have repacked the gland on...
Replies
7
Views
191
Timmy D
T
F
  • Question
No Hot water, Fixed and Broken Again Ideal Logic 24
Ideal Logic 24, Previous problem was that the hot water was only cold or barely warm if the heating was in use. If heating was off and boiler cold then would get hot water most of the time. Changing the flow cartridge about 2 years ago (when I moved in) solved this problem enough to suffer it as...
Replies
2
Views
139
Lou
Lou
127bit
How to reinforce shower pan threshold?
The left rear floor corner is highest (the shower pan touches/sits on the floor), sloping down diagonally to the front right corner (lowest). The front right corner shim is 5/8", the left front corner is 3/8" shimmed, with shorter shims under left middle and right rear corner. The pan perimeters...
Replies
5
Views
149
Timmy D
T
Creating content since 2001. Untold Media.

Newest Plumbing Threads

Tiling Tools for Beginners
Tiling News
Tiling Advice
TilersForums.co.uk
Tiling Forum UK
Back
Top
AdBlock Detected

We get it, advertisements are annoying!

Sure, ad-blocking software does a great job at blocking ads, but it also blocks useful features of our website. For the best site experience please disable your AdBlocker.

I've Disabled AdBlock