Search the forum,

Discuss Riello rs180 in the Plumbing Jobs | The Job-board area at PlumbersForums.net

Status
Not open for further replies.

gasmanrob

Plumbers Arms member
Plumber
Gas Engineer
Messages
3,238
Been warned today I'm going to look at one of these next week with intermittent lock out. It's bolted to a viessman and has a gas train I've seen it in passing but never paid it any attention. This will be my first time solo on such a beast and was wondering if anyone had any similar dealings with them/common faults I could tick of first. Apparently it will light on 2nd reset and run happily for anything from an hour to a week.

thanks in advance. GMR
 
Lovely and short there jc. Is that a common issue or just a previous issue you've had?

billy the manuals are all there in about 17 different languages with print as big as the cheap adverts in the Thompson local..
 
They do but I usually find the fault Rob's described is down to the IP.
 
I'm not totally sure it is. I only know/guess what it is as I took a peek in the manual when passing through to the hw service valves back in December. It looks identical to that although I don't recall the triangular unit on the right hand side of it.
 
Status
Not open for further replies.

Reply to Riello rs180 in the Plumbing Jobs | The Job-board area at PlumbersForums.net

Similar plumbing topics

Every two weeks or so I have to go and top up the system because the hot taps are running cold. Boiler display is flashing 0.6 bar and I fill up to 1.3. I've had an engineer look inside the boiler and he can't see anything wrong. I've checked the pipes all over the house and cannot see any...
Replies
2
Views
237
P
Hi all I'm hoping someone can shine a light on this for me Since our stop tap on the pavement has now been filled with sand for whatever reason, we are relying on our property fitted stopcock (this is outside on our garage wall) Unfortunately turning this to the closed position only reduces...
Replies
3
Views
292
Hello plumbers in my internet. So the Mrs want a spray mixer tap in the kitchen as we had two separate taps. I changed the tap for a temporary two hole mixer but the cold water pressure is high mains fed and the hot is low pressure immersion tank fed. I've been trying to find info on what I...
Replies
2
Views
168
Hello I am looking to install a slimline dishwasher (integrated) into a cupboard in my kitchen. The depth of the dishwasher is 550mm and the depth of my cupboard is larger than this. The issue, however, is that the waste pipe which leads from the sink (next door cupboard) comes out quite a...
Replies
22
Views
471
Hi, Can anyone advise as to why the cold water to my bathroom keeps airlocking? This originally happened about 12 months ago and has happened 3-4 times since. It’s an upstairs bathroom, fed from a tank in the attic. The tank is about 8 Meters away and feeds a bath, sink and toilet. The tank...
Replies
9
Views
376
Creating content since 2001. Untold Media.

Newest Plumbing Threads

Back
Top
AdBlock Detected

We get it, advertisements are annoying!

Sure, ad-blocking software does a great job at blocking ads, but it also blocks useful features of our website. For the best site experience please disable your AdBlocker.

I've Disabled AdBlock