Rads

Post new thread

Discuss Rads in the Plumbing Jobs | The Job-board area at PlumbersForums.net

Status
Not open for further replies.
measure it, ie 600mm x 1000mm, then wether its a double or single panel, then look at a manufacturers catalouge online (Biasi, Kermi, etc etc).
 
For a rough idea, measure radiator then look in Screwfix catalogue.
 
Status
Not open for further replies.

Reply to Rads in the Plumbing Jobs | The Job-board area at PlumbersForums.net

Similar plumbing topics

P
Viessmann combi starts when cold, mixer, tap is opened
Recently had a Viessmann Vitodens combi boiler installed, quite often when the adjacent cold mixer tap is opened the boiler starts for a few...
Replies
3
Views
239
ShaunCorbs
ShaunCorbs
N
Towel Rail Valve Advice please (35 Characters needed.)
I have had a look at previous posts and think I know the answer to this but just before I make it worse could I just check what you think about...
Replies
7
Views
257
Timmy D
T
D
Extending outdoor tap and drain
Hello all, I'm would like to extend an existing outside tap to another point in the garden. I'm about to pour a concrete patio and was hoping to...
Replies
6
Views
287
DIwhYdidIstartThis
D
C
Mixer bar fitting solutions?
The fittings below are for a mixer bar attached to a self contained shower. i.e not a wall. The attaching screws have snapped. I could get two new...
Replies
1
Views
268
SimonG
SimonG
T
22mm MDPE connection
I want to reconnect some outbuildings to an existing water supply. The supply pipe is old 22mm MDPE and buried for a fair distance so not going...
Replies
1
Views
318
ShaunCorbs
ShaunCorbs

Newest Plumbing Threads

Back
Top
AdBlock Detected

We get it, advertisements are annoying!

Sure, ad-blocking software does a great job at blocking ads, but it also blocks useful features of our website. For the best site experience please disable your AdBlocker.

I've Disabled AdBlock