Search the forum,

Problem finding thermostat for Purmo radiator.

Post new thread

Discuss Problem finding thermostat for Purmo radiator. in the USA area at PlumbersForums.net

P

Patdoc

Messages
3
I am having problems finding a thermostat for my radiator. The radiator is a Purmo radiator and is about 15 years old. I have tried two replacements but none have fitted.
 
This is the valve that I am finding problems to replace the thermostat with.
 

Attachments

  • 20220105_144712.jpg
    20220105_144712.jpg
    287.4 KB · Views: 11
Yep danfoss ras c2
 

Reply to Problem finding thermostat for Purmo radiator. in the USA area at PlumbersForums.net

Similar plumbing topics

S
Advice needed for a mixer Spray for kitchen ?
Hello plumbers in my internet. So the Mrs want a spray mixer tap in the kitchen as we had two separate taps. I changed the tap for a temporary two hole mixer but the cold water pressure is high mains fed and the hot is low pressure immersion tank fed. I've been trying to find info on what I...
Replies
2
Views
114
Lou
Lou
N
Towel Rail Valve Advice please (35 Characters needed.)
I have had a look at previous posts and think I know the answer to this but just before I make it worse could I just check what you think about this one. Granddaughter just moved house and this valve decided to leak when it was closed. When open its fine. Normally I have repacked the gland on...
Replies
7
Views
184
Timmy D
T
M
Central heating losing pressure all the time
Every two weeks or so I have to go and top up the system because the hot taps are running cold. Boiler display is flashing 0.6 bar and I fill up to 1.3. I've had an engineer look inside the boiler and he can't see anything wrong. I've checked the pipes all over the house and cannot see any...
Replies
1
Views
132
fowlerboi
F
C
Greenstar Boiler Not Working
I have a green star ten yrs old keeps increasing pressure, feel on off filling valve not working, drain off to recommended, but after few days it's increased whilst cold...is this a regular problem.
Replies
1
Views
140
Lou
Lou
T
22mm MDPE connection
I want to reconnect some outbuildings to an existing water supply. The supply pipe is old 22mm MDPE and buried for a fair distance so not going to dig it up and replace it šŸ˜¬. Question is can I use normal 22mm plumbing push-fit connectors to make the connection as finding 22mm MDPE fittings...
Replies
1
Views
263
ShaunCorbs
ShaunCorbs
Creating content since 2001. Untold Media.

Newest Plumbing Threads

Back
Top
AdBlock Detected

We get it, advertisements are annoying!

Sure, ad-blocking software does a great job at blocking ads, but it also blocks useful features of our website. For the best site experience please disable your AdBlocker.

I've Disabled AdBlock