Pls Help: Boiler on, but no hot water or CH

[Zack]

Hi All, really hoping for some advice as a very cold family up here in Manchester.

Have a Baxi Solo 2. The boiler turning on fine, all the orange lights on as expected. Can see pilot light and can hear boiler fire up.
But getting no hot water or CH, no matter what position I put the programmer in.
None of the radiators are warming up, even the closest. Have reached behind the boiler and none of the pipes seem to be getting hot even with boiler on.
Have a Wilo pump, and if I adjust the speed up and down can here the change in flow.
Motorised valve doesn't seem to be stuck. Have removed it and manually adjusted the valve but no difference.

The only change I have noticed is that when the boiler is on, it would normally cut out after a couple of mins once up to temp. Since today, if I turn it on, it just stays on.

Cant understand why none of the pipes exiting the boiler are hot??

Please, and advice gratefully received.

Regards Zack

 

[ShaunCorbs]

When you hear it ramp up how long before it drops out again ??

And have you tried opening the port valves manually by using the lever on the side of them ?

 

[Zack]

Once boiler kicks in, it isnt kicking out again like it normally would, just stays on permanently, unless I turn off at the programmer. Yes tried the mid port valve in various positions, but no difference.
No strange noises or kettling from the boiler either, even if been on ages.
Very confused.

 

[ShaunCorbs]

And you can see flames (other than the pilot)

That is strange the pipes should heat up

 

[Zack]

I can definitely see pilot light kick in and stay on. But how would see the rest of the flames? Glass viewer isn't big enough to see rest flames. Sounds like their are on but can't be sure. Is there another way to check?

With casing off, would you expect the front of boiler to get very hot, as it is staying cold?

 

[ShaunCorbs]

You should be able to tell when the main burner is on (you will hear a sound difference when it lights like a woooof)

 

[Zack]

Yeah, can definitely hear the whoosh sound, is if everything is firing as normal.

 

[ShaunCorbs]

You should have heat on the pipes above the boiler

Any chance of a few pics of the boiler / cylinder/ where the pump is ?

 

[Zack]

Please see attached.

 

[ShaunCorbs]

pumps not on in pic?

 

[Zack]

Sorry here you go. All lights on the boiler just can't see cause of flash.

 

[Zack]

Just noticed that the flue outside is blowing out cold air. This is normally hot air.

 

[ShaunCorbs]

i would say its not firing (on full flame) just pilot, tbh you need a gas safe engy mate could be a few things

 

[Zack]

Think you are right, initially thought it was sludge or airlock blockage, but clearly the issue is in the boiler itself. Thanks for the help.

 

[ShaunCorbs]

if it was sludge or an air lock the pipes on show to the right would get hot