Search the forum,

Discuss Permanent rad removal? in the Central Heating Forum area at PlumbersForums.net

macka09

Plumbers Arms member
Plumber
Gas Engineer
Messages
1,226
Is there anything in the regs that I’m unaware off to stop us from removing a radiator permanently?? Silly question no doubt.

When removing new build rads, that are obviously piped in plastic, are you just cap ending them and pushing them in the wall or going back to a fitting in the floor upstairs?
 
Cap and push back into the wall / back box
 
Yes always
 
Well guys,

I had a look at the above job and it’s not as straight forward as it sounds, unless I’m overthinking it as usual.

The rad to come off is being replaced with a log burner and I can’t leave the pipe work in the wall because the flue is going straight out the back of the burner.

My initial thought was to go upstairs and remove the drops completely but the floor above is tiled. So I’m thinking cut and cap the pipes just below the coving down stairs. My worry is the extreme heat from the log burner affecting the plastic pipes behind the plaster board??

I doubt it would be an issue but as I say, I’m an overthinker/worrier.
 
Open the ceiling up and cap there
 
Open the ceiling up and cap there
It was more the hassle of making good tbf. Although I’m sure they’re decorating once the burner has been installed.

She also wants the hallway rad moving along the wall, so they’ll be more decorating issues there as she doesn’t want any pipes on show. Redrew new build property so it’s all plastic pipe and stud walls.
 

Reply to Permanent rad removal? in the Central Heating Forum area at PlumbersForums.net

Similar plumbing topics

I have had a look at previous posts and think I know the answer to this but just before I make it worse could I just check what you think about this one. Granddaughter just moved house and this valve decided to leak when it was closed. When open its fine. Normally I have repacked the gland on...
Replies
7
Views
184
Hello all, I’m replacing a concrete paving slab patio in the back yard. The original patio used 50mm deep concrete slabs on hardcore & sand. I’m planning to pour a 100mm deep concrete patio on 100mm hardcore. In order to achieve the same final height to line up with the rest of the patio, I...
Replies
6
Views
231
I was stupid enough not to check the position of the pipes under the tiles when installing a toilet and drilled right through the center of a 16 mm copper water pipe. I exposed the pipe by removing a ~30cm section of the plastic sleeve and a ~10 cm section of the pipe around the hole. Several...
Replies
0
Views
187
I want to reconnect some outbuildings to an existing water supply. The supply pipe is old 22mm MDPE and buried for a fair distance so not going to dig it up and replace it 😬. Question is can I use normal 22mm plumbing push-fit connectors to make the connection as finding 22mm MDPE fittings...
Replies
1
Views
264
Hi, Can anyone advise as to why the cold water to my bathroom keeps airlocking? This originally happened about 12 months ago and has happened 3-4 times since. It’s an upstairs bathroom, fed from a tank in the attic. The tank is about 8 Meters away and feeds a bath, sink and toilet. The tank...
Replies
9
Views
323
Creating content since 2001. Untold Media.

Newest Plumbing Threads

Back
Top
AdBlock Detected

We get it, advertisements are annoying!

Sure, ad-blocking software does a great job at blocking ads, but it also blocks useful features of our website. For the best site experience please disable your AdBlocker.

I've Disabled AdBlock