Search the forum,

Discuss Logic Accredited Course! Yes or No? in the Plumbing Jobs | The Job-board area at PlumbersForums.net

Status
Not open for further replies.
Messages
12
I am looking to a gas engineering course which apparently is a Logic Accredited Course and at the end of it i will receive a logic certificate. And i then do a re-assessment every 5 years.
Can anyone tell me is this certificate a recognised qualification and will it allow me to register with Gas Safe and start their probationary period.
 
Have you any past training or plumbing experience?
 
yes as long as you pass all the relevant courses that you have applied for you must undergo training first before you can be assessed on a logic accredited course
 
I am going to be completing BPEC Level 2 in Domestic Plumbing and a BPEC Level 2 NVQ in Plumbing - you will also complete and receive a WRAS Certificate and an Unvented Hot Water Systems Certificate. And hoping to complete Gas with intention to register with Gas Safe but never heard of logic certificate so didn't believe it was correct.
 
You would have to complete level 2 first and to complete that, you will need to be working with a qualified engineer for a year and a day and complete a work based portfolio. This is before you can get gas safe qualified.
 
after you have passd you traning at college you will be assesssed at a logic accredited course if you pass this you can apply for gas safe.
 
Thank you well once i have completed the courses i am hoping to have a workplace lined up to enable i complete my portfolio. appreciate the advice
 
after you have passd you traning at college you will be assesssed at a logic accredited course if you pass this you can apply for gas safe.
Thank you for that i believe that is lined up for once i have had a work placement then go for the assessment/exam
 
32 years for me!!

To the op.
Don't wait until the end of the two years to get a job. That's what eveelse does. Go look for one Now. Start working weekends, or take it full time. College will adapt.
 
Status
Not open for further replies.

Reply to Logic Accredited Course! Yes or No? in the Plumbing Jobs | The Job-board area at PlumbersForums.net

Similar plumbing topics

We run a community village hall and have a large kitchen provided for the use of hirers. This includes a Lincat SLR9 gas cooker which I believe is a 23.8Kw appliance with all six burners and oven on max. This was installed some 10 years ago and has passed all subsequent Gas Safety inspections as...
Replies
5
Views
402
Hi, Can anyone advise as to why the cold water to my bathroom keeps airlocking? This originally happened about 12 months ago and has happened 3-4 times since. It’s an upstairs bathroom, fed from a tank in the attic. The tank is about 8 Meters away and feeds a bath, sink and toilet. The tank...
Replies
9
Views
316
I was stupid enough not to check the position of the pipes under the tiles when installing a toilet and drilled right through the center of a 16 mm copper water pipe. I exposed the pipe by removing a ~30cm section of the plastic sleeve and a ~10 cm section of the pipe around the hole. Several...
Replies
0
Views
182
Hello all, I’m replacing a concrete paving slab patio in the back yard. The original patio used 50mm deep concrete slabs on hardcore & sand. I’m planning to pour a 100mm deep concrete patio on 100mm hardcore. In order to achieve the same final height to line up with the rest of the patio, I...
Replies
6
Views
225
Creating content since 2001. Untold Media.

Newest Plumbing Threads

Back
Top
AdBlock Detected

We get it, advertisements are annoying!

Sure, ad-blocking software does a great job at blocking ads, but it also blocks useful features of our website. For the best site experience please disable your AdBlocker.

I've Disabled AdBlock