Search the forum,

Kitchen tap, replacing the O rings on the spout.

Post new thread

Discuss Kitchen tap, replacing the O rings on the spout. in the UK Plumbing Forum | Plumbing Advice area at PlumbersForums.net

SMB

SMB

Messages
52
Hi,
I need to replace the O rings on the spout of my kitchen tap.
What lubricant do I need to use in order to aid fitting the new O rings.

Searched and failed again!
 
Always used Regin Silicon Grease, WRAS approved and always does the job
 

Attachments

  • Screenshot_20231111_135323_Samsung Internet.jpg
    Screenshot_20231111_135323_Samsung Internet.jpg
    146.1 KB · Views: 6

Reply to Kitchen tap, replacing the O rings on the spout. in the UK Plumbing Forum | Plumbing Advice area at PlumbersForums.net

Similar plumbing topics

B
Brass tap body is leaking.
I have attached an image of the brass body within a tap. Having replaced a cartridge which has cured a leaking tap, I can see that there is a small leak from the brass body which can be unscrewed. Is there a seal behind the body? Thanks.
Replies
2
Views
296
Bp89
B
C
How to identify dripping tap.
Our kitchen mixer tap has started dripping. Like so much of the plumbing in our almost new build bungalow, it is lacking! The plumber didn't install any isolating cocks in the H&C feed to the tap so how can I identify which of the valves is passing? Shut the whole H&C water system down?
Replies
12
Views
324
Timmy D
T
C
Mixer bar fitting solutions?
The fittings below are for a mixer bar attached to a self contained shower. i.e not a wall. The attaching screws have snapped. I could get two new brackets, dismantle that existing one and start again or I could try and re attach via those screws, removing the broken ones from the plate and wall...
Replies
1
Views
194
SimonG
SimonG
jamespipe
Plumber recommendation for heat pump HWS installation
Hi, My current hot water system needs to be replaced. Anyone got any suggestions or can recommend any plumbers around Derrimut area that won't rip me off? An office guy recommended me to apply for government rebates and get it installed through timetosave.com.au. How reliable is this...
Replies
6
Views
286
oz-plumber
O
T
22mm MDPE connection
I want to reconnect some outbuildings to an existing water supply. The supply pipe is old 22mm MDPE and buried for a fair distance so not going to dig it up and replace it šŸ˜¬. Question is can I use normal 22mm plumbing push-fit connectors to make the connection as finding 22mm MDPE fittings...
Replies
1
Views
263
ShaunCorbs
ShaunCorbs
Creating content since 2001. Untold Media.

Newest Plumbing Threads

Back
Top
AdBlock Detected

We get it, advertisements are annoying!

Sure, ad-blocking software does a great job at blocking ads, but it also blocks useful features of our website. For the best site experience please disable your AdBlocker.

I've Disabled AdBlock