Search the forum,

Discuss Instantaneous hot water heater in the USA area at PlumbersForums.net

Matt0029

Gas Engineer
Messages
1,136
How do these compare to the 5/10 litre storage under sink heaters?
 

Attachments

  • Screenshot_2021-11-30-22-06-14-13_40deb401b9ffe8e1df2f1cc5ba480b12.jpg
    Screenshot_2021-11-30-22-06-14-13_40deb401b9ffe8e1df2f1cc5ba480b12.jpg
    271.6 KB · Views: 7
A pita for sparkie was they need a 10mm cable min
 
Could be a problem if there where 2 of these and an electric shower in a property as the board is limited to 100amp?

Yep tbh your pushing it at 2 including the shower
 
Imo they don't last as long as an undersink storage. Not as reliable. Also mi's usually specify not to use for kitchen sink, ie handwash only.
 
It would just be a wash hand basin was looking at these ones only 4.4kw more viesable.
 

Attachments

  • Screenshot_2021-12-02-21-17-04-62_40deb401b9ffe8e1df2f1cc5ba480b12.jpg
    Screenshot_2021-12-02-21-17-04-62_40deb401b9ffe8e1df2f1cc5ba480b12.jpg
    213.1 KB · Views: 7

Reply to Instantaneous hot water heater in the USA area at PlumbersForums.net

Similar plumbing topics

Has anyone one fit or serviced one of these before; Heatrae Sadia 25l 9004010. It a 25 litre hot water storage cylinder.
Replies
39
Views
653
  • Question
Ideal Logic 24, Previous problem was that the hot water was only cold or barely warm if the heating was in use. If heating was off and boiler cold then would get hot water most of the time. Changing the flow cartridge about 2 years ago (when I moved in) solved this problem enough to suffer it as...
Replies
2
Views
126
The left rear floor corner is highest (the shower pan touches/sits on the floor), sloping down diagonally to the front right corner (lowest). The front right corner shim is 5/8", the left front corner is 3/8" shimmed, with shorter shims under left middle and right rear corner. The pan perimeters...
Replies
5
Views
131
Hi everyone, Looking for a bit of advice, recently went to a job where heating was operating when called for however not for the hot water. I have changed the 3 port actuator Honeywell head however this doesn’t seem to have solved the issue, does this mean that the programmer is faulty? Or is...
Replies
8
Views
277
Hi, My current hot water system needs to be replaced. Anyone got any suggestions or can recommend any plumbers around Derrimut area that won't rip me off? An office guy recommended me to apply for government rebates and get it installed through timetosave.com.au. How reliable is this...
Replies
6
Views
293
Creating content since 2001. Untold Media.

Newest Plumbing Threads

Back
Top
AdBlock Detected

We get it, advertisements are annoying!

Sure, ad-blocking software does a great job at blocking ads, but it also blocks useful features of our website. For the best site experience please disable your AdBlocker.

I've Disabled AdBlock