Search the forum,

Discuss Help! Don't know what to choose. in the Central Heating Forum area at PlumbersForums.net

Messages
1
So, I have bought a 3-bed semi and in the middle of renovating it. In the process we have removed the gas supply and going all electric.
We have radiators sorted, but the thing we are struggling with, is hot water for bath shower, kitchen and downstairs toilet?

Would it be worth having a separate instantaneous heater for the kitchen, bathroom, and downstairs toilet?

Bathroom: https://www.elementshop.co.uk/stieb...KFXFXq9ggQDnz6yHGMQ-Q1LxTne3MnXwaArQ8EALw_wcB

Kitchen: https://www.boilersandtaps.co.uk/in...neous-inline-water-heater-9.6 kw-thermostatic

Downstairs toilet: Redring RP1 Powerstream 9.5kW Instant Water Heater - https://www.boilersandtaps.co.uk/instant-hot-water-boilers/electric-water-heaters/redring-rp1-powerstream-9.5kw-instant-water-heater


Or would there be a better option out there for us?
 
120l - 150l unvented

Have to spoke to your sparks as two of them is 100 amps which is over your incoming supply
 
Would it be worth having a separate instantaneous heater for the kitchen, bathroom, and downstairs toilet?

Bathroom: https://www.elementshop.co.uk/stieb...KFXFXq9ggQDnz6yHGMQ-Q1LxTne3MnXwaArQ8EALw_wcB
Your chosen heater here is 3-phase. It's unlikely you have a 3-phase supply or metering, and the cost of upgrading could be typically £3.5k to £5.5k. But that might then give you a chance of simultaneously running all the loads you describe.

For me, as per Shaun, an unvented hot water storage tank would be the way to go.

At least from my supplier, a kilowatt of heat from my gas boiler is approx one-fifth the price of a kilowatt of electricity, so I hope you have done the sums!
 
So, I have bought a 3-bed semi and in the middle of renovating it. In the process we have removed the gas supply and going all electric.
We have radiators sorted, but the thing we are struggling with, is hot water for bath shower, kitchen and downstairs toilet?

Would it be worth having a separate instantaneous heater for the kitchen, bathroom, and downstairs toilet?

Bathroom: https://www.elementshop.co.uk/stieb...KFXFXq9ggQDnz6yHGMQ-Q1LxTne3MnXwaArQ8EALw_wcB

Kitchen: https://www.boilersandtaps.co.uk/instant-hot-water-boilers/electric-water-heaters/hyco-aquila-instantaneous-inline-water-heater-9.6 kw-thermostatic

Downstairs toilet: Redring RP1 Powerstream 9.5kW Instant Water Heater - https://www.boilersandtaps.co.uk/instant-hot-water-boilers/electric-water-heaters/redring-rp1-powerstream-9.5kw-instant-water-heater


Or would there be a better option out there for us?
Since you are renovating your house and will be insulating it well, consider a air to water heat pump, a 15kw unit should be more than enough and its ~ 3.5/4kw compressor will only require 17 to 20 amps single phase. You should run it with as low a temp as possible, say 40/45C to give a reasonable COP, it can also heat your water to acceptable levels and you can just boost the whole cylinder once/week to 60C with a electric immersion for legionella protection, it should reduce your ( all) electric bill options to ~ 30 to 40%.
 

Reply to Help! Don't know what to choose. in the Central Heating Forum area at PlumbersForums.net

Similar plumbing topics

  • Question
Ideal Logic 24, Previous problem was that the hot water was only cold or barely warm if the heating was in use. If heating was off and boiler cold then would get hot water most of the time. Changing the flow cartridge about 2 years ago (when I moved in) solved this problem enough to suffer it as...
Replies
2
Views
139
Hi, Can anyone advise as to why the cold water to my bathroom keeps airlocking? This originally happened about 12 months ago and has happened 3-4 times since. It’s an upstairs bathroom, fed from a tank in the attic. The tank is about 8 Meters away and feeds a bath, sink and toilet. The tank...
Replies
9
Views
339
Hello plumbers in my internet. So the Mrs want a spray mixer tap in the kitchen as we had two separate taps. I changed the tap for a temporary two hole mixer but the cold water pressure is high mains fed and the hot is low pressure immersion tank fed. I've been trying to find info on what I...
Replies
2
Views
135
Creating content since 2001. Untold Media.

Newest Plumbing Threads

Back
Top
AdBlock Detected

We get it, advertisements are annoying!

Sure, ad-blocking software does a great job at blocking ads, but it also blocks useful features of our website. For the best site experience please disable your AdBlocker.

I've Disabled AdBlock