K
kevbis
Hello Guys,
I have had a recent problem with a Heatline Vizo 24 which developed a leak from the diverter valve and as a result started blowing the micro fuses on the PCB.
I have had the leak fixed by uing a repair kit and have also replaced the actuator motor.
The problem is the fuses on the PCB have continued to blow although not as frequently as before.
The fuses I have have used as replacements are 630mA. I am wondering if they are rated too low-I didn't keep the originals so am not sure now what the originals were rated at-does anyone have any idea the correct rated fuses to use or is there another potential fault within the boiler?
Thanks in anticipation
I have had a recent problem with a Heatline Vizo 24 which developed a leak from the diverter valve and as a result started blowing the micro fuses on the PCB.
I have had the leak fixed by uing a repair kit and have also replaced the actuator motor.
The problem is the fuses on the PCB have continued to blow although not as frequently as before.
The fuses I have have used as replacements are 630mA. I am wondering if they are rated too low-I didn't keep the originals so am not sure now what the originals were rated at-does anyone have any idea the correct rated fuses to use or is there another potential fault within the boiler?
Thanks in anticipation