Search the forum,

exposed pipework to bar mixer

Post new thread

Discuss exposed pipework to bar mixer in the Plumbing Jobs | The Job-board area at PlumbersForums.net

Status
Not open for further replies.
M

mutley racers

Esteemed
Plumber
Gas Engineer
Subscribed
Messages
5,172
What fittings do you guys use to get it as close to the wall as possible. Do you just use chrome tap back plates with a couple of 1/2 × 3/3 female irons? I think you will still end up seeing a bit of the iron from the valve though. cheers chaps
 
Ok, just found the proper chrome elbows for exposed pipe work on the williams and co website. So not to worry guys and girls. :)
 
Status
Not open for further replies.

Reply to exposed pipework to bar mixer in the Plumbing Jobs | The Job-board area at PlumbersForums.net

Similar plumbing topics

dreikher
Hole in copper pipe, solder under floor, T coupling & protection
I was stupid enough not to check the position of the pipes under the tiles when installing a toilet and drilled right through the center of a 16 mm copper water pipe. I exposed the pipe by removing a ~30cm section of the plastic sleeve and a ~10 cm section of the pipe around the hole. Several...
Replies
0
Views
190
dreikher
dreikher
P
Repeated Airlock in Bathroom
Hi, Can anyone advise as to why the cold water to my bathroom keeps airlocking? This originally happened about 12 months ago and has happened 3-4 times since. It’s an upstairs bathroom, fed from a tank in the attic. The tank is about 8 Meters away and feeds a bath, sink and toilet. The tank...
Replies
9
Views
344
Chuck
C
Creating content since 2001. Untold Media.

Newest Plumbing Threads

Tile Blog
Electrical Advice
BS 5389 Tiling Standards
UK Tiling Forum
Plumbers Forum - Plumbing Advice
Back
Top
AdBlock Detected

We get it, advertisements are annoying!

Sure, ad-blocking software does a great job at blocking ads, but it also blocks useful features of our website. For the best site experience please disable your AdBlocker.

I've Disabled AdBlock