Search the forum,

Discuss exposed pipework to bar mixer in the Plumbing Jobs | The Job-board area at PlumbersForums.net

Status
Not open for further replies.

mutley racers

Plumbers Arms member
Plumber
Gas Engineer
Messages
5,167
What fittings do you guys use to get it as close to the wall as possible. Do you just use chrome tap back plates with a couple of 1/2 × 3/3 female irons? I think you will still end up seeing a bit of the iron from the valve though. cheers chaps
 
Ok, just found the proper chrome elbows for exposed pipe work on the williams and co website. So not to worry guys and girls. :)
 
Status
Not open for further replies.

Reply to exposed pipework to bar mixer in the Plumbing Jobs | The Job-board area at PlumbersForums.net

Creating content since 2001. Untold Media.

OFFICIAL SPONSORS

OFFICIAL SPONSORS

Back
Top
AdBlock Detected

We get it, advertisements are annoying!

Sure, ad-blocking software does a great job at blocking ads, but it also blocks useful features of our website. For the best site experience please disable your AdBlocker.

I've Disabled AdBlock