Discuss Can't figure out how to remove speed fit pipe fitting in the Plumbing Jobs | The Job-board area at PlumbersForums.net
- Status
- Messages
- 8,642
Two fingers on the thin ring on the outside of the fitting and then pull towards the fitting whilst pulling the pipe away in the opposite direction ..... turn the water off first lol
- Messages
- 7,712
As town fan said.
Sometimes tho they can jam a bit
Sometimes tho they can jam a bit
- Messages
- 34,360
- Solutions
- 2
twist and pull
- Messages
- 6,157
Can i ask what you are planning to do once you have disconnected it please kop.
- Messages
- 967
Looks like the collar on left has been broken off. get a Plumber in!
- Status
Reply to Can't figure out how to remove speed fit pipe fitting in the Plumbing Jobs | The Job-board area at PlumbersForums.net
Similar plumbing topics
The fittings below are for a mixer bar attached to a self contained shower. i.e not a wall. The attaching screws have snapped. I could get two new...
I was stupid enough not to check the position of the pipes under the tiles when installing a toilet and drilled right through the center of a 16...
I have had a look at previous posts and think I know the answer to this but just before I make it worse could I just check what you think about...
I want to reconnect some outbuildings to an existing water supply. The supply pipe is old 22mm MDPE and buried for a fair distance so not going...
Hello
I am looking to install a slimline dishwasher (integrated) into a cupboard in my kitchen.
The depth of the dishwasher is 550mm and the...
Creating content since 2001. Untold Media.