Search the forum,

Discuss Can this Bristan shower valve be fixed in the USA area at PlumbersForums.net

Messages
6
I have a Bristan Trinity shower which gives out hot and very hot water. I have removed the valve and checked that there is high flow in both hot and cold water pipes. I have also descaled the valve. Is there a way of fixing the valve or is a case of just buy a new one.
Valve is CART 06732COMPL
Thanks
 
Most showers can be repaired. The hardest two parts of the job is getting the correct parts for the shower but this sounds like you already have that covered with a new thermostatic valve part no. Secondly getting the old valve out can sometimes be the deciding factor. We never repair parts its not worth the time/effort just buy a new one.

If your shower is a concealed shower, ie buried in the wall behind tiling then yes it would be well worth trying to repair but with new parts only! If you are upgrading your bathroom in the near future then no as the cost of the parts are a considerable amount versus the cost of the shower.

Hope that helps :)
 
Look at the cost of cartridge versus cost of a new bar shower.

Have you tried adjusting the temperature via the cartridge?
 
Look on here might help you buy the correct part.
or here
 
Thanks. The site lists parts for the non concealed valve. Mine is concealed. it should be the same but what I took out looks very different.
If you go to their website and upload pictures of your valve, before dismantled and the cartridge. They will be able to assist you with the correct part.
 

Reply to Can this Bristan shower valve be fixed in the USA area at PlumbersForums.net

Similar plumbing topics

  • Question
Ideal Logic 24, Previous problem was that the hot water was only cold or barely warm if the heating was in use. If heating was off and boiler cold then would get hot water most of the time. Changing the flow cartridge about 2 years ago (when I moved in) solved this problem enough to suffer it as...
Replies
2
Views
147
I have had a look at previous posts and think I know the answer to this but just before I make it worse could I just check what you think about this one. Granddaughter just moved house and this valve decided to leak when it was closed. When open its fine. Normally I have repacked the gland on...
Replies
7
Views
207
Hi All I have a leak coming from within my Mira Elite QT shower. It seems to be flowing from behind the switching Control. Any ideas what could be causing this leak. Already Changed the Pump Elbow as one of the clips had popped which was causing a second small leak, Any idea? Is it time to buy...
Replies
0
Views
244
Every two weeks or so I have to go and top up the system because the hot taps are running cold. Boiler display is flashing 0.6 bar and I fill up to 1.3. I've had an engineer look inside the boiler and he can't see anything wrong. I've checked the pipes all over the house and cannot see any...
Replies
2
Views
226
P
Hello plumbers in my internet. So the Mrs want a spray mixer tap in the kitchen as we had two separate taps. I changed the tap for a temporary two hole mixer but the cold water pressure is high mains fed and the hot is low pressure immersion tank fed. I've been trying to find info on what I...
Replies
2
Views
153
Creating content since 2001. Untold Media.

Newest Plumbing Threads

Back
Top
AdBlock Detected

We get it, advertisements are annoying!

Sure, ad-blocking software does a great job at blocking ads, but it also blocks useful features of our website. For the best site experience please disable your AdBlocker.

I've Disabled AdBlock