Discuss CADENT (NATIONAL GRID) in the Plumbing Jobs | The Job-board area at PlumbersForums.net

Status
Not open for further replies.
Nope I've had 14 that's the lowest
 
I had 4mb once. Could only just get a flame on boiler, went out when cooker turned on.

Don't know why you asked grid to disconnect.

Phoned it in and they they came out and fixed it within two hours as usual.
 
He couldn’t get it any better and it needs a new main. He couldn’t get anyone out until tomorrow.
 
Grid would not cut off a supply 'cos an RGI asked them to. The RGI presents the problem, and they decide upon the appropriate (in there view) course of action
True dat mate. True dat. I was hoping they would fix it there and then. But then again wasn’t he the one that said he would do a boiler change for £1000.00?
 
tbh nation grid Sod me off. By me they now wont touch a main that has 17mb or higher at ecv nut. They wont test with the boiler in service mode so moduation gives them another excuse. they have lowered gas mains pressures to around 25mb because the mains leak so bad. they will try anything to avoid costs.

the other problem is they are paying private contractors to plastic line the mains, these guys are on price work and tend to do a really bad job. sometimes they use 16mm pipe inside the old main and if its found out after 2 years the private companys warranty is passed so the grid has to pay to replace. total codge job.
 
There is loads of main grid replacement going on around my way at the moment. Putting smaller pipework inside the old has resulted in many properties having a low service pressure. When I have called them (many times this year) they have come out replaced the main properly and then buggered off.
 
Status
Not open for further replies.

Reply to CADENT (NATIONAL GRID) in the Plumbing Jobs | The Job-board area at PlumbersForums.net

Similar plumbing topics

Had conventional boiler and tanks removed last year and new combi fitted and just recently had it serviced but the guy who did it has given me a...
Replies
9
Views
785
Hi, I have fitted an electric shower, teed off the toilet cold feed (Mains) The pressure for the shower is very very poor just dribbling out...
Replies
9
Views
340
Hello plumbers in my internet. So the Mrs want a spray mixer tap in the kitchen as we had two separate taps. I changed the tap for a temporary two...
Replies
2
Views
235
    • Informative
Why am I not surprised? Britain’s gas network still using engines from 1960s RAF fighter jets Ageing aircraft turbines will cost millions to...
Replies
4
Views
663
C
We've just purchased a grohe vitalio joy 260 not realising the shower riser rail is not adjustable and it is too long/tall for our shower it hits...
Replies
1
Views
320
Back
Top
AdBlock Detected

We get it, advertisements are annoying!

Sure, ad-blocking software does a great job at blocking ads, but it also blocks useful features of our website. For the best site experience please disable your AdBlocker.

I've Disabled AdBlock