Users can remove all display ads (not sponsors) for a small fee. Click for info (must be logged in)

Discuss Boiler - Central Heating in the Plumbing Jobs | The Job-board area at PlumbersForums.net

Status
Not open for further replies.
Messages
7
I have an issue which may go over my ability and may need a registered tradeperson. I have a Ideal Logic Heat 12 boiler and it is on time and come on at 630am and off at 8.30am and on at 4pm and off at 10am. However the boiler fires up between these times and go on for about 5 minutes before turning off again. The CH and HW lights on the timer do not come on. This could happen during the day and mostly at night including one time where I had to turn the boiler off at the timer. Can anyone confirm if this is a boiler issue or is the timer not working. They are danfloss. HELP
 
Thanks for reply. Would the boiler have one because to get the frost protection in action I have to turn boiler off which then automatically put the frost protection on at 5C.
 
Had heating engineer in and he checked the system and said he can see no problems and that the heating will kick in overnight every time when the temperature falls below 20degrees but only upstairs. Don't think that is correct as surely should only come on when it is timed to come on.
 
Status
Not open for further replies.

Reply to Boiler - Central Heating in the Plumbing Jobs | The Job-board area at PlumbersForums.net

Similar plumbing topics

Hi, I have a Worcester 28i junior boiler that has started to lose pressure, only when using the central heating. When using hot water I have no...
Replies
6
Views
253
Hello, I am looking for a heating engineer to diagnose and resolve an issue with my Vaillant EcoTec 832 combi boiler. Job Location: Copeland Rd...
Replies
1
Views
422
M
Hello, We’ve recently moved into a fairly old, fairly big detached house (i.e. fairly draughty, but not too bad by any means) with a fairly new...
Replies
0
Views
282
MartinPod81
M
Hi, I have a Vailant EcoTec Boiler with a Megaflo. These are controlled by a Honeywell controller. I have one 3 port diverter, where one of the...
Replies
5
Views
272
Good afternoon, I am experiencing a pressure issue with my heating system and was hoping to receive additional insight as to what the problem...
Replies
9
Views
395
Back
Top
AdBlock Detected

We get it, advertisements are annoying!

Sure, ad-blocking software does a great job at blocking ads, but it also blocks useful features of our website. For the best site experience please disable your AdBlocker.

I've Disabled AdBlock