You are using an out of date browser. It may not display this or other websites correctly. You should upgrade or use an alternative browser.
firing
Dismissal (also called firing) is the termination of employment by an employer against the will of the employee. Though such a decision can be made by an employer for a variety of reasons, ranging from an economic downturn to performance-related problems on the part of the employee, being fired has a strong stigma in some cultures.
To be dismissed, as opposed to quitting voluntarily (or being laid off), is often perceived as being the employee's fault. Finding new employment may often be difficult after being fired, particularly if there is a history of being terminated from a previous job, if the reason for firing is for some serious infraction, or the employee did not keep the job very long. Job seekers will often not mention jobs that they were fired from on their resumes; accordingly, unexplained gaps in employment are often regarded as a red flag.
Hi,
I have a Vailant EcoTec Boiler with a Megaflo. These are controlled by a Honeywell controller. I have one 3 port diverter, where one of the outputs goes to a 2 port diverter prior to the Megaflo (I believe this is some safety feature).
I have run into an intermittent problem where some...
Went to a customer today their glow worm Ultracom 24 HE goes to fire up then cuts out turning the heating pump off, then does the same again before firing and running. Occasionally shows the flame is lit on display but flow temp doesn’t go much past 26. Then if you turn off and try again...
Hi all,
Hope you’re all doing well.
I had a new bathroom installed recently which involved new piping, and also capping off some redundant pipes. Since then, my boiler (pretty new Vaillant combi) turns on when I turn the cold water on. I’ve done some reading and it seems like the problem is...
Hi all...got some issues....drained my working ok system yesterday to upgrade some 15 to 22 on the flow and return rad circuit.
Refilled and bled up.
Fired boiler up, had hot water and rads for 3-4 hours...
Turned off to cool.
Boiler would not fire on timer later, demand wouldnt work either...
Heatslave 18/25 not firing.
No heating or hot water but no lockout light and diverter switch is locked in place.
Hot water was scalding hot earlier despite being set at a middling temp on the boiler and now there’s no CH or hot water.
Makes a whirring noise but nothing fires up when we call for...
Hi, we're in an old, complicated house with 3 heating zones - two run via Nest with radiators, and working well. UFH in the kitchen worked fine last winter, but now when I call for heat the boiler doesn't fire up. It does fire up if I call for heat via the Nest/radiators in the old part of the...
Hi all, sorry but im after a bit of advice.
I have a problem where my boiler randomly fires up 2/3/4 times a day when there is no call for heat or hot water.
My setup:
Unvented system
Ideal HE 18 boiler ( installed around 2013)
Tribune HE tank
2 zones (upstairs & downstairs)
Plus hot water
3x...
Hi, I am having an issue with my conventional boiler not firing up when my thermostat calls for the heating to be turned on. I have a Hive Thermostat and Receiver which seem to be working well. The lights turn on on the receiver as per schedules. When hot water is called for the boiler fires up...
Lee Holden
Thread
boiler
central heating system
firing
heating
hot
hot water
water
Afternoon, hoping to get some advice:
I’ve just drained my central heating system to remove 2 upstairs radiators, and now after refilling, the boiler won’t fire up.
The mains light is on, no lock-out light, the thermostat is set to 30*C, all radiators are bled, pressure is at 1 bar, there is...
Hi! I'm wondering if anyone can help me get my radiators on :)
My Salus ST620WBC ran out of battery after ticking over nicely for years. Got it back on OK
.... but now the 'reciever' on the boiler (a Worchester Combi 30si) is not working. It was left with no signal for a day yesterday. I got...
Please help, I'm losing my mind.
Over the past week my boiler has been coming on even when the programmer is set to off. It doesn't matter if I change it to off or if it's set not to be on because of the timer. Was working as expected up to that point.
I've done a factory reset on the...
Hello,
I replaced a Heatmiser Neostat V1 (stopped working) with a Neostat V2 for my Vaillant ecoTec plus 637 boiler, using it as a timer to turn the central heating on. It was a direct replacement of the ‘front’ unit without any change to the existing back plate or wiring (I am neither a...
Hello everyone, I am looking for some help with this boiler. This problem has only just started in the last few weeks and only happens when it has been a long time (5/6 hours) between timer on settings and when it has been cold.
Common time is at 06.00 when timer is set to come on for the...
my Vokera Mynute16e stopped working , pressure is1.5 bar. when I try the reset I get a click and also a noise like its going to start but then it does'nt ive had the burner cover off and when its off it does fire up but onlt lasts a few seconds
Morning all, hope I can get some help here without calling out an engineer again.
Long story short, we had an old RF mechanical clock-type stat for our Ideal Logic Combi 24 .. clock broke so we had it replaced by an engineer with a Salus RT520RF. Not the best make but seems a pro can get it...
Hello, hopefully posting this in the right place. Have a Baxi duo-tec boiler that is not firing up for water or heating. The green 'hot water' led lights, showing that there is demand for hot water when the hot tap is turned on, but boiler does not even attempt to fire up. Heating initially...
My Logic Combi 30 Boiler was working fine. Whilst servicing it, the hot water stopped firing up although the heating still works. . Engineer said these cheap boilers often do this when turned off and back on again and now it needs a flow something. Is this correct please? He also had a leak...
Builder at my house went through oil line has been repaired and oil purged back to boiler. Now it wont fire but it doesn't lock out either. Motor runs, fan runs. It goes to fire but then wont hold the flame. keeps trying to ignite every 15 seconds but never locks out. I have checked photocell...
I have a rayburn 480AG but it has stopped firing up. The pilot lights are both lit fine and a good colour but neither is firing. I don't have a local rayburn engineer but do know a corgi registered guy. Please help.
Sure, ad-blocking software does a great job at blocking ads, but it also blocks useful features of our website. For the best site experience please disable your AdBlocker.