Search the forum,

Discuss Anyone fitted an Ideal Standard i.life S Basin & Full Pedestal? in the UK Plumbing Forum | Plumbing Advice area at PlumbersForums.net

Messages
4
Has anyone fitted an Ideal Standard i.life S 50cm compact washbasin with a matching i.life S & B full pedestal?

The basin is T518501 and pedestal is T519901.

I have a problem with the pedestal boxed and packaged as the T519901 (but marked T2839 inside as below) - it does not fit and from the I.S. catalogue both the T519901 and T2839 are very different pedestals....

The three spokes under the i.life basin do not sit on the T2839, but look like it would on the T519901? As it stands (or rather does not stand), the current pedestal sent appears unsafe to fit...
T519901 Close Up.png
Rim of T2839 Esedra.jpg
Bottom of T518501 Basin.jpeg
i life seated on the esedra - a .jpg
 
Would say wrong ped
 
Would say wrong ped
Many thanks! Yes, I believe it's been packaged incorrectly at the production end (not any distributors fault!); but trying to get an 'office person' at I.S. to understand the technical side of the ped is becoming quite challenging... A few minutes trying to put one together at their Hull distribution centre would confirm this pretty quickly...
 
Many thanks! Yes, I believe it's been packaged incorrectly at the production end (not any distributors fault!); but trying to get an 'office person' at I.S. to understand the technical side of the ped is becoming quite challenging... A few minutes trying to put one together at their Hull distribution centre would confirm this pretty quickly...

If you email ideal standard they should be able to confirm then send that to your supplier etc
 
If you email ideal standard they should be able to confirm then send that to your supplier etc
It's quite delicate, I have and they ['office person'] claim it should fit; I disagree, which is why I am trying to contact anyone who has fitted this type as I am going around & around in circles.. It's for a Hotel and the room remains unused whilst this continues, so the pressure is on...!
 
Despite what appears to be the wrong ped shown on the I.S. catalogue and adding to the confusion, we have now fitted the supplied ped and it fits with a good bit of silicone!
 

Reply to Anyone fitted an Ideal Standard i.life S Basin & Full Pedestal? in the UK Plumbing Forum | Plumbing Advice area at PlumbersForums.net

Similar plumbing topics

The fittings below are for a mixer bar attached to a self contained shower. i.e not a wall. The attaching screws have snapped. I could get two new brackets, dismantle that existing one and start again or I could try and re attach via those screws, removing the broken ones from the plate and wall...
Replies
1
Views
182
Hi all I'm hoping someone can shine a light on this for me Since our stop tap on the pavement has now been filled with sand for whatever reason, we are relying on our property fitted stopcock (this is outside on our garage wall) Unfortunately turning this to the closed position only reduces...
Replies
3
Views
234
Hi, basic question, any insight much appreciated. Looking to have an outdoor tap in my front porch fed from 15mm pex coming up from suspended floor. Pic 1 is inside porch, pex temporarily clipped to give an idea of pipe placement (ignore shoddy blockwork of booted cowboy builder!), Pic 2 is...
Replies
6
Views
219
Hi, Can anyone advise as to why the cold water to my bathroom keeps airlocking? This originally happened about 12 months ago and has happened 3-4 times since. It’s an upstairs bathroom, fed from a tank in the attic. The tank is about 8 Meters away and feeds a bath, sink and toilet. The tank...
Replies
9
Views
310
Hello all, I'm would like to extend an existing outside tap to another point in the garden. I'm about to pour a concrete patio and was hoping to run the water line underneath. There are existing drain (and who knows what) pipes running along the same wall so I'm nervous about digging too far...
Replies
6
Views
215
Creating content since 2001. Untold Media.

Newest Plumbing Threads

Back
Top
AdBlock Detected

We get it, advertisements are annoying!

Sure, ad-blocking software does a great job at blocking ads, but it also blocks useful features of our website. For the best site experience please disable your AdBlocker.

I've Disabled AdBlock