anton analyser not reading correctly?

[MP plumb]

i done a gas service today and i used the anton to do a tightness test. i went though the motion of the let by, then stabilisation then the tightness,and all was fine until it got to the tightness... i was about a min in when suddenly it completly dropped to a minus. I redone the test, and all was fine, could my analyser be faulty?
btw, aparantly no one had turned anything on whilst i was testing.

 

[Barry98]

no one had turned anything on , HA if i had a dime for every , never mind

what about boiler kicking in ora hot tap if its a combi

 

[CMairiD]

Ditto Bod. Someone tried to ignite.

 

[MP plumb]

there was only 2 people in the house, and one of them was in kitchen with me... the other, im not sure, but i turned boiler off so the pilot light was off, so even if they did turn tap on, nothing would of happened. if it was a leak, the let by and stabilisation would of failed, surley?

...dont call me shirley..

(ok, rubbish joke)

 

[Barry98]

ok but can we call you Cinderella , did it pass when you did the test again, and i say this because ive done i myself but the hose didnt come loose on the bottom of the anton did it

 

[MP plumb]

you can call me cinderella when u guess my shoe size?!!... and when you come along with your glass coach and 'dog alike' horses? yes it passed the second time on tightness, but i didnt touch the tube, i just reset it and tried again because i didnt beleive the first reading.

 

[Barry98]

Size 3-4

 

[MP plumb]

nope....8-9

 

[MP plumb]

hahahah..... only jokin! thought id shock u a bit. im a 5-6, depending on wheta shop i go to, pretty average. x

 

[Barry98]

Ghee was going to say 5 too lol