Search the forum,

Discuss 2 rads. Of 10mm drops in the Australia area at PlumbersForums.net

Matt0029

Gas Engineer
Messages
1,137
I have a friend who wants a radiator adding to his system in the garage. His proposing teeing off the 10mm pipe drops to the rad. Behind the garage wall in the kitchen. How big will this be heat wise? It's a new build so all piped from a central manifold in 10mm and can't really get to it to repipe. Thanks. The rads are 1000 by 600 in garage and I think kitchen a tad smaller.
 
Agree no go the only way is to pipe them in series eg flow into one return out of that into the flow of another return out of that into the return pipe will take a tad longer to heat but should heat up
 
I’ve had no success teeing into 10mm done it twice, both time only one rad at a time works.
never mind what customer says, take it back to mains
 

Reply to 2 rads. Of 10mm drops in the Australia area at PlumbersForums.net

Similar plumbing topics

Every two weeks or so I have to go and top up the system because the hot taps are running cold. Boiler display is flashing 0.6 bar and I fill up to 1.3. I've had an engineer look inside the boiler and he can't see anything wrong. I've checked the pipes all over the house and cannot see any...
Replies
2
Views
209
P
  • Question
Ideal Logic 24, Previous problem was that the hot water was only cold or barely warm if the heating was in use. If heating was off and boiler cold then would get hot water most of the time. Changing the flow cartridge about 2 years ago (when I moved in) solved this problem enough to suffer it as...
Replies
2
Views
141
We run a community village hall and have a large kitchen provided for the use of hirers. This includes a Lincat SLR9 gas cooker which I believe is a 23.8Kw appliance with all six burners and oven on max. This was installed some 10 years ago and has passed all subsequent Gas Safety inspections as...
Replies
5
Views
481
Hello plumbers in my internet. So the Mrs want a spray mixer tap in the kitchen as we had two separate taps. I changed the tap for a temporary two hole mixer but the cold water pressure is high mains fed and the hot is low pressure immersion tank fed. I've been trying to find info on what I...
Replies
2
Views
140
Creating content since 2001. Untold Media.

Newest Plumbing Threads

Back
Top
AdBlock Detected

We get it, advertisements are annoying!

Sure, ad-blocking software does a great job at blocking ads, but it also blocks useful features of our website. For the best site experience please disable your AdBlocker.

I've Disabled AdBlock