Search the forum,

Discuss What is this pipe? in the USA area at PlumbersForums.net

Messages
4
We have moved into a Victorian semi and trying to figure out the plumbing. There is an outhouse not connected to the house and there is a small pipe - any ideas what this is and if it connects to neighbours at all?

Also, on the back of the house the waste water pipe which is on the outside of the house is connected to the neighbours waste water - is this normal? Can this be changed?

Thanks do much!
 
We have moved into a Victorian semi and trying to figure out the plumbing. There is an outhouse not connected to the house and there is a small pipe - any ideas what this is and if it connects to neighbours at all?

Also, on the back of the house the waste water pipe which is on the outside of the house is connected to the neighbours waste water - is this normal? Can this be changed?

Thanks do much!
You'll need to provide some photos / sketches. I don't think it's possible to answer your questions based on the information in your original post.

The issue with waste water is probably one you need to raise with whoever conveyanced the house. I suggest you don't bring the issue to your neighbour's attention until you understand the position. And maybe not even then...
 
We have moved into a Victorian semi and trying to figure out the plumbing. There is an outhouse not connected to the house and there is a small pipe - any ideas what this is and if it connects to neighbours at all?

Also, on the back of the house the waste water pipe which is on the outside of the house is connected to the neighbours waste water - is this normal? Can this be changed?

Thanks do much!
 
6094F25E-F745-4582-8D87-815399F52217.png
 
Regarding the back of the main building (as I can't see the small pipe on the outhouse): you share a soil and vent pipe with a neighbour - looks like their pipe goes into yours? I'm not sure why this is a problem. Even if you had separate SVPs, it's almost certain you'd share a sewer.

Generally houses are sold together with any rights that may have been granted or acquired over time (easements). Such as access rights, rights of support, rights to light, right to have your water main under the neighbour's garden perhaps. My house has a flat roof that leans on a neighbour's extension by ancient agreement and my neighbour cannot take that wall down now as I have a right to use it for support of my flat roof. If it's been like that for ages, whoever is providing, as it were, a service to the other half, is obliged to continue to do so.

What's the problem?
 
Regarding the back of the main building (as I can't see the small pipe on the outhouse): you share a soil and vent pipe with a neighbour - looks like their pipe goes into yours? I'm not sure why this is a problem. Even if you had separate SVPs, it's almost certain you'd share a sewer.

Generally houses are sold together with any rights that may have been granted or acquired over time (easements). Such as access rights, rights of support, rights to light, right to have your water main under the neighbour's garden perhaps. My house has a flat roof that leans on a neighbour's extension by ancient agreement and my neighbour cannot take that wall down now as I have a right to use it for support of my flat roof. If it's been like that for ages, whoever is providing, as it were, a service to the other half, is obliged to continue to do so.other wall

What's the problem?
We want to move the toilet to the other wall - so would need a new waste pipe and thinking through what the options would be for the cast iron pipe if we do that. It seems to make sense to rid of the old pipe and the neighbour get their own and we have our own on the other wall.....
 
1. If you start tinkering with old cast iron pipe, you will probably have to replace the lot with plastic. Neighbour might object to paying for something he / she doesn't need.
2. The pipe will almost certainly go straight down into manhole or similar. If you move the pipe you would probably have to move the manhole, which looks as if it may be under the floor of your outhouse.
3. Not sure what other wall you would want to put the soil pipe onto. Don't forget it should have a vent at the top, and must have a connection to the sewer system at the bottom. It can't have any bends in the wet bit unless there is good rodding access to clear blockages. Bends are frowned on anyway because they can cause blockages.
4. There must be at least on WC in the property which connects directly to the sewer. You are not allowed to have all WCs (or the only one) emptied via a macerator pump.
 
You wouldnā€™t move the existing stack. It would stay in place and youā€™d cap off your unused connection.

Then youā€™d have to install a new stack/vent/sewer connection for the new toilet location. Loads of headache/cost.

However, you may be able to run a pipe from the new toilet location and connect to the existing stack.

Iā€™ve done loads of new plastic to 100 year old cast without issue. Just use the correct fittings for the job (time saver couplings).
 

Reply to What is this pipe? in the USA area at PlumbersForums.net

Similar plumbing topics

Hello all, Iā€™m replacing a concrete paving slab patio in the back yard. The original patio used 50mm deep concrete slabs on hardcore & sand. Iā€™m planning to pour a 100mm deep concrete patio on 100mm hardcore. In order to achieve the same final height to line up with the rest of the patio, I...
Replies
6
Views
231
I want to reconnect some outbuildings to an existing water supply. The supply pipe is old 22mm MDPE and buried for a fair distance so not going to dig it up and replace it šŸ˜¬. Question is can I use normal 22mm plumbing push-fit connectors to make the connection as finding 22mm MDPE fittings...
Replies
1
Views
262
Hello, I am seeking some advice, I have a POTTERTON PROMAX 28 COMBI Boiler and I noticed yesterday that the water around the house is no longer warming up. The heat exchanger has been changed 6 months ago, so I do not believe it is that. Does anyone have any ideas on what it could be? Thanks
Replies
4
Views
223
I was stupid enough not to check the position of the pipes under the tiles when installing a toilet and drilled right through the center of a 16 mm copper water pipe. I exposed the pipe by removing a ~30cm section of the plastic sleeve and a ~10 cm section of the pipe around the hole. Several...
Replies
0
Views
186
  • Question
Ideal Logic 24, Previous problem was that the hot water was only cold or barely warm if the heating was in use. If heating was off and boiler cold then would get hot water most of the time. Changing the flow cartridge about 2 years ago (when I moved in) solved this problem enough to suffer it as...
Replies
2
Views
120
Creating content since 2001. Untold Media.

Newest Plumbing Threads

Back
Top
AdBlock Detected

We get it, advertisements are annoying!

Sure, ad-blocking software does a great job at blocking ads, but it also blocks useful features of our website. For the best site experience please disable your AdBlocker.

I've Disabled AdBlock