Search the forum,

Discuss Water tank and water query in the UK Plumbing Forum | Plumbing Advice area at PlumbersForums.net

Messages
276
Hi everyone,

I have a query which I hope I can get advice on. I live on a top floor flat in a block of 6 the water is mains fed in the kitchen and bathroom but the attic has common water tanks which I believe feed the hot water and are cleaned annually.
My kitchen has a gas combi boiler.

Question:
The common water tank is going to be disconnected and I want to know if it is a good idea and safer in the long run?
I have good pressure throughout the flat and are most properties these days fed via mains fed or are people still using water tanks in attics?
Also I have a thermostatic mixer shower so would a isolation valve need to be installed on my shower and if so where would it be installed?

Thank you and I would appreciate any information or advice
 
It’ll be cheaper in the long run for the building owner as there’d be no annual clean out. It might be safer in terms of undue warming and frost prevention but that’s about it. You have a combi boiler, so better showers. Some showers state isolation valves should be fitted, but iirc it’s not a requirement of the water regulations.
 
If the common tank only supplies hot water but you aren't using it as you have a combi then it won't affect you. As for the others, while I like having some water stored in the house, it is technically safer not to store water.

Lots of cisterns are still in use and I still come across more houses with a cistern than with all-mains pressure systems. Obviously the system connected to them needs to be designed with the resultant low-pressure in mind.

It does sound like the changes won't affect you or your shower.
 

Reply to Water tank and water query in the UK Plumbing Forum | Plumbing Advice area at PlumbersForums.net

Similar plumbing topics

Our kitchen mixer tap has started dripping. Like so much of the plumbing in our almost new build bungalow, it is lacking! The plumber didn't install any isolating cocks in the H&C feed to the tap so how can I identify which of the valves is passing? Shut the whole H&C water system down?
Replies
12
Views
316
Hi, Can anyone advise as to why the cold water to my bathroom keeps airlocking? This originally happened about 12 months ago and has happened 3-4 times since. It’s an upstairs bathroom, fed from a tank in the attic. The tank is about 8 Meters away and feeds a bath, sink and toilet. The tank...
Replies
9
Views
314
Hi all Noticed bad smell in my drain out side put my hand down and it unclogged it for now however I checked my sewer drain and after flushing my toilet a good few times nothing is going to the sewer so don't know is there a blockage or what way it works many thanks and advice would be grateful
Replies
3
Views
473
I want to reconnect some outbuildings to an existing water supply. The supply pipe is old 22mm MDPE and buried for a fair distance so not going to dig it up and replace it 😬. Question is can I use normal 22mm plumbing push-fit connectors to make the connection as finding 22mm MDPE fittings...
Replies
1
Views
259
Creating content since 2001. Untold Media.

Newest Plumbing Threads

Back
Top
AdBlock Detected

We get it, advertisements are annoying!

Sure, ad-blocking software does a great job at blocking ads, but it also blocks useful features of our website. For the best site experience please disable your AdBlocker.

I've Disabled AdBlock