Discuss No heating but got hot water in the Central Heating Forum area at PlumbersForums.net

Messages
5
Have a Alpha InTec 30c combi that gives me hot water but boiler cuts out after 30 seconds when calling for heating. It then restarts and tries to go for another 30 seconds and restarts. When I turn on hot water for around 15mins then swap to heating, the boiler then works... Could diverter valve be faulty. Thanks in advance
 

Reply to No heating but got hot water in the Central Heating Forum area at PlumbersForums.net

Similar plumbing topics

Hi, I have a Vailant EcoTec Boiler with a Megaflo. These are controlled by a Honeywell controller. I have one 3 port diverter, where one of the...
Replies
5
Views
294
  • Question
Ideal Logic 24, Previous problem was that the hot water was only cold or barely warm if the heating was in use. If heating was off and boiler cold...
Replies
2
Views
306
  • Question
Milky hot water. Recently had a Viessmann 100-W combi boiler installed. Now when the hot water reaches any tap it is very 'milky'. This appears to...
Replies
1
Views
444
Hi everyone, Looking for a bit of advice, recently went to a job where heating was operating when called for however not for the hot water. I...
Replies
8
Views
503
Heating and hot water is not working. Plenty of heating oil. I have replaced batteries in thermostat and it seems to be working ok, showing flame...
Replies
5
Views
404
Back
Top
AdBlock Detected

We get it, advertisements are annoying!

Sure, ad-blocking software does a great job at blocking ads, but it also blocks useful features of our website. For the best site experience please disable your AdBlocker.

I've Disabled AdBlock