Search the forum,

Discuss Do old lead pipe's ever wiped onto cast iron? in the Plumbing Jobs | The Job-board area at PlumbersForums.net

Status
Not open for further replies.
J

jarnty

I have an old Victorian building with a bath with an old lead pipe connected to the cast iron drain pipe outside , i just need to if is likely to be wiped 'soldered' directly on to the iron or is it most likely that there is a brass fitting that the lead is wiped onto before the cast iron drain pipe?
 
Hi & welcome to the forum!
Hard to say without photos. The lead waste is unlikely to be soldered to cast iron. Sometimes the cast iron stack was sealed with molten lead at joints, but not usually lead pipes.
Often waste pipes to baths & basins if any great length were done in cast iron & the lead waste pipe just went the short distance & to inside the larger cast pipe a few inches.
 
Unusual. They normally drop into a cast iron hopper half way up.
Does it look like there was a cast iron hopper there.
Tell tale marks are a number of wooden pegs in the mortar where it would have been attached with perhaps cleaner looking brickwork in that area.

Cant think ive seen a lead pipe straight into a cast iron but I havent had 5 coffees yet and its still early ;)
 
Status
Not open for further replies.

Reply to Do old lead pipe's ever wiped onto cast iron? in the Plumbing Jobs | The Job-board area at PlumbersForums.net

Similar plumbing topics

I want to reconnect some outbuildings to an existing water supply. The supply pipe is old 22mm MDPE and buried for a fair distance so not going to dig it up and replace it 😬. Question is can I use normal 22mm plumbing push-fit connectors to make the connection as finding 22mm MDPE fittings...
Replies
1
Views
264
Hi, I have an old steel water mains pipe (approx 45mm) that I need to connect to a new pehd water mains (25mm). I can't get at it to create a new thread so what's the best way of connecting the two? Cheers, Peter
Replies
2
Views
193
Hello all, I’m replacing a concrete paving slab patio in the back yard. The original patio used 50mm deep concrete slabs on hardcore & sand. I’m planning to pour a 100mm deep concrete patio on 100mm hardcore. In order to achieve the same final height to line up with the rest of the patio, I...
Replies
6
Views
232
Hello all, I'm would like to extend an existing outside tap to another point in the garden. I'm about to pour a concrete patio and was hoping to run the water line underneath. There are existing drain (and who knows what) pipes running along the same wall so I'm nervous about digging too far...
Replies
6
Views
227
S
Hi, I seemed to have a blockage in kitchen sink. A plumber came and cleared all the pipework that is visible inside my home (there was debris and pebbles!) We saw that the pipe that takes water down the gutter was visibly full to the top. He said he will return with a coil to push through...
Replies
1
Views
50
Creating content since 2001. Untold Media.

Newest Plumbing Threads

Back
Top
AdBlock Detected

We get it, advertisements are annoying!

Sure, ad-blocking software does a great job at blocking ads, but it also blocks useful features of our website. For the best site experience please disable your AdBlocker.

I've Disabled AdBlock