Discuss Can someone advise on the fitting. in the USA area at PlumbersForums.net
It will limit the maximum flow rate slightly but probably not to a significant extent depending on the length and bends in the rest of the run and the design of the mixer. These days, it's common practice to use 15mm tubing to supply baths if the supply is unvented.Is this elbow good to go. Goes from 15mm speedfit to 15mm copper then out to mixer. Will this bend cause any reduce in pressure.
As already said, don't bury compression fittings. Also, in my opinion, if you are going to bury pipework under expensive finishes with no access you should pressure test it.Need to check as I don’t want to start hacking off the plasterboard on the next room to gain access if a problem occurred.
Ah, too late to clean up. Put the fittings in this morning. Was made u for me by a plumber, was he just being lazy.Fine as far as I can tell. Give it a clean though.
Reply to Can someone advise on the fitting. in the USA area at PlumbersForums.net
We get it, advertisements are annoying!
Sure, ad-blocking software does a great job at blocking ads, but it also blocks useful features of our website. For the best site experience please disable your AdBlocker.