C
Chris Lyon
I have a fair degree of experience with 15/22/28 mm fittings in both compression & solder but I am now fitting an UFH manifold which has flow and return presented in 1" BSP fittings. All fine, I have various of these fittings that convert to 22mm compression. All would be lovely if it wasn't for the fact that one of them is a right angle fitting ( the hot flow enters from the bottom of the mixing valve whilst the return exits on the horizontal. Tightening this right angle 1" to 22mm fitting ends up with the right angle pointing in completely the opposite direction from which I want it to go. I could use lots of PTFE tape or boss white or such, but I was hoping there is a actually a procedure for such a situation, would for instance a fibre washer correct for this by being a half turn pitch or does one just tape and adjust amd tape and adjust till it all comes good?