I use
15/22/28 pipeslice (not rothenberger as I got through 1 of each size in about 6 weeks)
Mini pipe cutter
Bahco wide jawed adjustable spanner (2 is ideal)
Bahco grips (10" as the grips are quite small so easier to get into tight spaces)
Crescent 12" grips
Wera screwdriver set
Voltage tester
Monument tap wrench (without a spring, you will hate it when you first get it after 7-8 years you will spend hours trying to find out what make they are so you can replace them.
Then cheap
Long nose pliers
Wire cutters
Stanley knife
Junior hacksaw
Wood chisel (a couple of sizes, I only buy cheap due to the amount of nails I hit)
Hammer
Cold chisel
If you do a lot of taps you need mono bloc spanners.
15/22/28 pipeslice (not rothenberger as I got through 1 of each size in about 6 weeks)
Mini pipe cutter
Bahco wide jawed adjustable spanner (2 is ideal)
Bahco grips (10" as the grips are quite small so easier to get into tight spaces)
Crescent 12" grips
Wera screwdriver set
Voltage tester
Monument tap wrench (without a spring, you will hate it when you first get it after 7-8 years you will spend hours trying to find out what make they are so you can replace them.
Then cheap
Long nose pliers
Wire cutters
Stanley knife
Junior hacksaw
Wood chisel (a couple of sizes, I only buy cheap due to the amount of nails I hit)
Hammer
Cold chisel
If you do a lot of taps you need mono bloc spanners.