Search the forum,

Anyone used this freezing kit?

Post new thread

Discuss Anyone used this freezing kit? in the USA area at PlumbersForums.net

Bogart

Bogart

Messages
578
Looking for a cheap freezing kit and came across this for the money looks good. Have used in the past the arctic where one measures out the freeze spray by means of a balance this looks a lot simpler. I just need it for the odd times I may need to shut off a rad or tap.
www.armarge.com

Icecap 2-Sleeve Pipe Freeze Kit

Icecap 2-Sleeve Pipe Freeze Kit with unique built in thermometers to take the guesswork out of spray pipe freezing
www.armarge.com
 

Reply to Anyone used this freezing kit? in the USA area at PlumbersForums.net

Similar plumbing topics

R
Multi Meter which one for engineers
Can anyone recommend a decent multi meter, preferably under a 100 pounds. It's for checking boiler components so I don't need a top spec one ....just easy to use and reliable. The fluke 115 looks good but its above my budget. My current socket and see one was great but it's developed a fault.
Replies
7
Views
218
oz-plumber
O
D
Extending outdoor tap and drain
Hello all, I'm would like to extend an existing outside tap to another point in the garden. I'm about to pour a concrete patio and was hoping to run the water line underneath. There are existing drain (and who knows what) pipes running along the same wall so I'm nervous about digging too far...
Replies
6
Views
224
DIwhYdidIstartThis
D
N
Towel Rail Valve Advice please (35 Characters needed.)
I have had a look at previous posts and think I know the answer to this but just before I make it worse could I just check what you think about this one. Granddaughter just moved house and this valve decided to leak when it was closed. When open its fine. Normally I have repacked the gland on...
Replies
7
Views
179
Timmy D
T
M
Unvented discharge at high level current regs
Hi they used to say as a last resort you could discharge the D2 pipework at high level and turn it back to the wall. Similar to a combi boiler. I have just looked back through the regs this seems to have changed and it isn't mentioned now. It now mentions if at high level it should be discharged...
Replies
11
Views
238
Matt0029
M
M
Central heating losing pressure all the time
Every two weeks or so I have to go and top up the system because the hot taps are running cold. Boiler display is flashing 0.6 bar and I fill up to 1.3. I've had an engineer look inside the boiler and he can't see anything wrong. I've checked the pipes all over the house and cannot see any...
Replies
1
Views
112
fowlerboi
F
Creating content since 2001. Untold Media.

Newest Plumbing Threads

Back
Top
AdBlock Detected

We get it, advertisements are annoying!

Sure, ad-blocking software does a great job at blocking ads, but it also blocks useful features of our website. For the best site experience please disable your AdBlocker.

I've Disabled AdBlock