Search the forum,

valve

A valve is a device or natural object that regulates, directs or controls the flow of a fluid (gases, liquids, fluidized solids, or slurries) by opening, closing, or partially obstructing various passageways. Valves are technically fittings, but are usually discussed as a separate category. In an open valve, fluid flows in a direction from higher pressure to lower pressure. The word is derived from the Latin valva, the moving part of a door, in turn from volvere, to turn, roll.
The simplest, and very ancient, valve is simply a freely hinged flap which swings down to obstruct fluid (gas or liquid) flow in one direction, but is pushed up by the flow itself when the flow is moving in the opposite direction. This is called a check valve, as it prevents or "checks" the flow in one direction. Modern control valves may regulate pressure or flow downstream and operate on sophisticated automation systems.
Valves have many uses, including controlling water for irrigation, industrial uses for controlling processes, residential uses such as on/off and pressure control to dish and clothes washers and taps in the home. Even aerosol spray cans have a tiny valve built in. Valves are also used in the military and transport sectors. In HVAC ductwork and other near-atmospheric air flows, valves are instead called dampers. In compressed air systems, however, valves are used with the most common type being ball valves.

View More On Wikipedia.org
  1. Hashtag246

    Thermostatic valve replacement problems

    Got a porcelanosa shower mixer and i need to change the thermostatic valve. It shows that a special tool might be required to remove it. Can u advise? Thanks
  2. A

    Urgent: drayton motorised valve z5 issue

    Hi, i am replacing a 2 port z5 drayton valve with a 3 port mid position drayton. Can anyone please tell me what changes i have to make to the wiring. Another post suggested: 'you have to connect both white and grey wires to where the brown wire of the old head was connected' I have cocked up...
  3. S

    How to replace UFH return pin valve

    Hello, I have UFH set up with a HIU in my flat. My issue is that one zone (Bedroom 2) does not heat up. All other zones working and heating as expected. Have checked the relevant thermostat, as well as the electrical actuator for the specific zone. Both look ok Checked return pin valve -...
  4. A

    Please help. When Heating on no hot water and vice-versa with Drayton 27101 - 3 port motorised valve

    We have a Drayton 27101 - 3 port motorised valve 22mm compression Issue: when heating switches on there is no hot water, when you switch heating off you get hot water. I replaced the motor in the motorised valve, everything started to work like it should. But an hour later and the same...
  5. C

    Can't find UFH manifold vent/drain valve

    Hi all, I can't locate the vent/drain valve on this manifold. My manifold resembles the "UFH Manifold RUB-RT1tm4" model on this webpage: https://www.thermo-floor.co.uk/underfloor-heating-manifolds.html I an intending to replace on the the actuator pin-valves and I think I need to drain (or at...
  6. A

    Replacing motorised valve steps

    Hi Folks, Please advise as i wish to change a motorised valve connected to a heat only gas boiler: Turn off the boiler Turn off the mains water Find a draining point and drain system Replace motorised valve Make sure draining point is closed. Turn on mains...
  7. M

    3/8s toilet fill valve

    If a toilet has a flush valve with a 3/8s thread. Does this mean the hole on the cistern is smaller? I want to fit a 1/2 threaded one in it.
  8. papachumba

    Is this Radiator Valve Adjustable?

    Hi all, have a radiator in the hallway which has never worked. When I bled the radiators few days ago I checked the hallway one, and it appears to have pressure. The valve on the right of the radiator is fully open, now the valve on the left I am confused about. It is the type with a small...
  9. Bookalon

    hot water cylinder control valve

    Hi, I have an oil burner which is controlled via Tado to heat my home. My hot water cylinder is heated with water from the burner and also has a dumb immersion. I don’t use the immersion at all And would like to replace it. The burner heats the water in my hot water cylinder with a TRV valve...
  10. J

    Fluidmaster - Fill valve

    Had a issue with a Fluidmaster fill valve plastic 1/2" fitting. After being installed with a B&Q slimline toilet had to keep adjusting as when filling always slightly overflowed. Checking today to ensure no debris was the issue, their was none though right replace unit. However on closer...
  11. J

    Radiators releasing heat when valve shut off

    Hi all, Today I noticed when the boiler is on, those radiators in the rooms I don't want heating are releasing heat even when the Drayton TRV4 valves fitted onto each of them are turned off all the way to the star symbol. Does anyone know why this is happening? Could it be due to the extra...
  12. C

    Humming vibrating pipes near mains inlet valve

    Not on the hot but whenever a cold tap is ran in the bathrooms or toilet flushed the two cold water pipes reverberate round the house. The cold mains and the balanced cold. We changed the water inlet valve with PRV last week but the problem has come back quickly. Is the street pressure too...
  13. johnnybaloney

    Toilet flush valve seals - unusual sizing

    Hello, Recently I received an unusually large water bill which led me to the discovery of leaking flush valves. I have two toilets and it turned out in both the valve seals were bubbling so I set out to replace them. For now I just flipped them over as the other side was smooth on both. The...
  14. S

    Adding Thermostatic Mixing Valve

    I have NuHeat UFH system, and this has no Thermostatic Blending valve on the heating circuit. (Heat Master II cylinder has pick up coil) Nu-Heat System installed - This means I can't run store above 60C due to risk of overheating UFH pipes. I want to add a Thermostatic Mixing valve so have...
  15. H

    Hello from a DIYer in Shropshire

    My toilet cistern has a black box inside hiding all the components. How do I sort out the problem I have with my toilet constantly running/emptying?
  16. daniel218

    Slow tap flow after new tap valve

    Recently had a repair done on a leaky tap they replaced the tap valve on my bathroom 1/4 turn taps, now the hot tap flow is slower What my problem please and what could I do to fix? They is no areiator on my taps
  17. User108

    How to remove this shower valve cartridge?

    My shower temperature control knob isn't working anymore - only produces hot water. I tried replacing the cartridge but I can't seem to remove the existing one. What's the best way to remove the cartridge I've attached pictures of? It's very very stiff.
  18. D

    Thermostatic radiator valve lets water through at 0

    Hi everyone. Apologies - I'm new, but I promise to try and be an active member of the forum :) We're doing some decorating just now and it was suggested that we take off the radiators to make it easier for the plasterer. We decided to have a go ourselves rather than getting someone in for...
  19. samwardill

    Use of microswitch on Honeywell 2-port valve for auxilliary pump

    My boiler struggled to circulate throughout my house so my heating engineer installed an auxilliary pump a few years ago. On a recent service he identified that the auxilliary pump was not working. He said that it was down to the motorised valve and he wants to charge £350 to replace it. He said...
  20. A

    Thermostic shower replace valve

    https://victoriaplum.com/browse/all-showers/type_Exposed-mixer-showers?csi=SHS30&ds_kid=92700067325954114&gclid=CjwKCAiA8OmdBhAgEiwAShr407d2c-jzpnzzY-36CoW00ayMz-g6iHjgD2mPTxyhm5U7HSwbT8bYCBoCt2QQAvD_BwE&gclsrc=aw.ds#&gid=1&pid=1 I have the above shower/bath thermostatic mixer shower/tap. Have...
Creating content since 2001. Untold Media.

Newest Plumbing Threads

Back
Top
AdBlock Detected

We get it, advertisements are annoying!

Sure, ad-blocking software does a great job at blocking ads, but it also blocks useful features of our website. For the best site experience please disable your AdBlocker.

I've Disabled AdBlock