5 amp fuse is blowing next to programmer. If I change fuse it might run for a while or instantly blow. I do not think there is anything wrong with controller or photoresistor .
thanks
Custard just rang, he has moved in 4 years ago and had a damp chimney in the loft, last summer they went up on the roof but didnt find any problems but still made good the pointing, flashing etc. The problem didnt happen over summer even when the rains came. SInce the boiler has been back on...
I got called to a breakdown to this boiler and found that the motor had given up because the pump had seized solid. Replaced both and set it up according to MI but now the tenant says that the boiler is starting up and switching off all the time, like it's skipping a beat.I haven't a clue as to...
Hello,
could anybody point me in the direction of a supplier either of a NOS seal or a suitable replacement boiler seal ?
The boiler is a Trianco WM 45/60 RS, the seal as I recall it is of a flattened U form, rope type which is fitted over the
pressed steel edge of the burner assembly inner...
Hi Guys, this burner has been working great for some years, it is serviced annually. Last week the burner cut-out after running for 2 minutes. The reset light came on in the Satronic box. I reset it and it cut out again after 2 minutes. All the filters have been cleaned or replaced, the nozzle...
Countryman65
Thread
after
burner
fault
minutes
problems
replaced
trianco
I wonder if anyone could offer some advice.
Our very ancient TRG100 needs replacing before it conks out and we are hoping to replace with a TRG80 as they no longer make the TRG100. Our current system also has a Monodraught Flue sytem. We are trying to locate a fitter/installer to come and offer...
hi got mark 1 at mo what to swap to mark to but only got 6" head room above boiler no problem with mark 1 front loader but mark 2 top loader if i open lid 6-7 inches will there be room to fill using a coal scuttle at a angle thanks terry
Hi...I have had a second hand trianco 90 boiler installed ...I went to see boiler working with plumber all went well installing boiler...but since being commisioned...hot water is great but I have to continually switch boiler on it heat up radiators then seems to switch off ...after a while it...
I've serviced a Trianco tro mk3,oil boiler. Replaced the correct nozzle to manufacturers instructions and the eletrodes are measured correctly under manufacturers instructions. Cleaned out the baffles and wipe the photocell clean. Correct the oil pressure to 116 psi. Done my flue anyliser test...
Might have stirred up a hornets nest here!
WoodEnergySolutions and marketing a small 15kW biomass boiler very similar to one sold by Trianco.
WES claim to be making them.
So - spoke to Trianco - now TR engineering, bought and now use the Trianco brand. and they claim emphatically, yes it...
OK - I have to admit it - having a 'Long' break from all this stuff is really causing me headaches and I need some help :)
I have a customer that has a Trianco Eurostar 100/125 external oil boiler (C2008) and I cannot get the burner to work. I have managed to determine that the control box was...
Chaps, Im running out of steam on this one..
Trianco Eurostar 90 (Sterling burner)
Low level balanced flue.
Plastic tank, no apparent water ingress.
Called out as boiler packed up - motor seized. Changed motor.
Called out about 6 months ago as it kept locking out. Didnt find much wrong with...
Hallo, May I pick the brains on a problem I have please?. I have an old (as in at least 30 years!) Trianco Redfyre 37/45 which is working ok, but surely cannot last much longer!.
I have the offer of a burner from the same maker supposidly in good (recently) reconditioned condition and which...
i am on a job where the radiators down stairs are heating good but the 3 upstairs rads have no heat whatsoever, the boiler is outside at back door of house and is working perfectly,pump sounds great and set at 3, radiators are full of water upstairs yet no heat apart from at one which has tiny...
markmonty
Thread
attic
cylinder
external
fed
fired
gravity
gravity fed system
oil
other
radiators
sounds
suggestions
system
trianco
upstairs
I have a Trianco WM50/70 wall mounted Oil Boiler, which is about 6-7 years old and a couple of years ago (after some 5years of fault free running) it started making what I can only describe as high pitched moaning noise when starting up and whilst running. It was intermittent initially but...
Hi,
Given we are struggling to find a reliable service engineer for the boiler and the fact that spares are virtually impossible to find we have decided to start looking at replacing the Trianco boiler.
Ideally I am looking for a reliable plumber who would be willing to assist in...
flanagaj
Thread
boiler
central heating system
engineer
gas
gas boiler
help
interested
oil
registered
replacing
trianco
hi everone , I have a old possible 15- 20 years old not sure trianco trg 45 solid fuel boiler i think,any way gravity hot water pumped heating, and the heating expansion tank in loft is getting hot and venting over ,the 22mm vent pipe coming of the hot water flow is getting hot and 15mm cold...
Sure, ad-blocking software does a great job at blocking ads, but it also blocks useful features of our website. For the best site experience please disable your AdBlocker.