You are using an out of date browser. It may not display this or other websites correctly. You should upgrade or use an alternative browser.
mixer shower
A vortex mixer, or vortexer, is a simple device used commonly in laboratories to mix small vials of liquid. It consists of an electric motor with the drive shaft oriented vertically and attached to a cupped rubber piece mounted slightly off-center. As the motor runs the rubber piece oscillates rapidly in a circular motion. When a test tube or other appropriate container is pressed into the rubber cup (or touched to its edge) the motion is transmitted to the liquid inside and a vortex is created. Most vortex mixers are designed with 2 or 4-plate formats, have variable speed settings ranging from 100 to 3,200 rpm, and can be set to run continuously, or to run only when downward pressure is applied to the rubber piece.
HI Guys
can any one help please.
Since having a custom made twin coil cylinder from Gledhill ( 1 side fed from solid fuel rayburn other gas boiler).
Pipework out of cylinder up 8 inch to tee, up for vent to cold water storage tank, across 16 inch before a tee down in 22mm pipe to bath...
Hi Long story short I have just moved into a property and I am not sure weather there is an actual problem or not. The Issue is the shower is not adjustable as there is just one constant temperature and it runs out after 6/7 minutes but goes scalding hot then stops all...
Hi I have a problem with my shower.
The hot is fed from a cylinder and the cold is mains.
We rarely use this shower as we use our other bathroom.
We had a problem in the other bathroom and had to drain the ccylinder.
While we also had to order some parts so we refilled the cylinder...
phillsmit3
Thread
could
hot
mixermixershower
other
pressure
problem
shower
Hello Friends
I've go to take off a bar mixer shower and replace it. Landlord doesn't know make, its a cheap one I think!!
So, the pipe centres should be 150mm.
I've seen showers with +\- 5mm.
Anyone know of one of these that are cheap? I'm talking £40 or less?
I can't trust the chap who...
Hi
As per my thread here: http://www.ukplumbersforums.co.uk/plumbing-forum/55817-unusual-shower-problem.html, I am looking for a plumber to remove a power shower and fit a mixer shower in Bradford BD15 area.
Regards
Paul
Hi everyone, this is my first post here on this forum and I'm hoping one of you good fella's can help me with a problem I've got. My father inlaw has a mixer shower which is only giving out cold water however I have hot water at all of the other outlets. From the picture does anyone know what...
I am looking to buy a new thermostatic exposed shower, to fit in my upstairs bathroom running of a valliant combi boiler in the kitchen downstream. Can the guys who are in the know help me select one of the below 3 choices i have narrowed down.
- Mira Discovery Concentric Thermostatic EV...
sri
Thread
advice
exposed
mixermixershower
need advice
shower
thermostatic
so i contacted Bristan and they sent me a new Cartdridge for a shower i fitted 3 months ago that had pressure/noise issues
i fitted it for the customer a week ago and she has just called me again today to say she has no hot water pressure but cold is fine
the tank is on the same level as the...
Hi
Above 10 year old shower mixer has died leaving a double problem. It required pipework at 96mm AND with Hot on the right.
Can anyone suggest a replacement either as a complete new unit with similar setup or an economic way to overcome both problems. It can be thermo or not, doesn't matter...
went to look at said shower and the handle has come off ,i dont know much about these and had to tell the customer i would have a read up and get back to her,have to go back to change a tap anyway so she was ok ,just wondering if anyone can help me the handle and spindle have come out of the...
I fitted a Bar mixer shower for a woman about 4 months ago when i did her complete bathroom
she called me yesterday and said all of a sudden the shower isnt even dribbling when she puts it on
& sometimes its comes on long enough for a shower but the on/off know seems to be making a whining...
Hello all.
I'm just looking for a bit of advice as our estate agents are causing a bit of a fuss and don't seem to want to acknowledge that there is a problem. All the taps taps in our house are boiling hot, but we have mixer shower which at the hottest setting, is at best, luke warm. When...
stasia
Thread
advice
check
cold
hot
mixermixershower
please
shower
tap
taps
though
wanted
water
Hi i have fitted a thermostatic shower but my combination boiler doesn't allow enough hot water pressure and flow. Can anyone make any suggestions? I've thought about fitting a pressure restricting valve to the cold line, or purchasing a water heater, to supply the shower. Would this be an...
colinbruce123
Thread
boiler
central heating system
cold
hot
hot water
hot water pressure
increase
mixermixershower
pressure
shower
thermostat
thermostatic
water
water pressure
I have a Mira mixer unit. The flow cartridge is faulty making the tap difficult to turn on. I sent for a replacement cartridge but was unable to remove the exisiting one as it was seized up and the depth of the part where the spanner fits is very narrow causing the spanner to slip off. Even...
AJR48
Thread
150mm
cartridge
mixermixershower
replacement
shower
spanner
units
Hello
I'm only qualified 11 months in plumbing.
Its things like this where I'm lacking in experience :
I installed a Salamander pump & a Bristan mixer shower to a customers house.
They just had a bath only in their bathroom on the 2nd floor. (Existing Shower room on the ground floor - with a...
a4drk
Thread
check
first
floor
installed
mixermixershower
pump
salamander
shower
starting
time
valves
Hi I'm experiencing problems with a mixer shower.
When the taps are run both hot and cold water exit the taps.
When the plunger is pulled up to divert the water to the shower head only cold comes out.
The hot water is certainly at a lower pressure than the cold - would this have anything to do...
blue2red
Thread
hot
hot water
mixermixershower
problem
shower
water
Hi, I currently have an electric shower with a cold water mains feed to it. I would like to fit a mixer shower ( head and controls on wall only) I have a conventional boiler (situated on ground floor) with cold water storage tank in my loft that feeds a cylinder in my airing cupboard (situated...
Flash987
Thread
fitting
mains
mixermixershower
pressure
question
shower
water
Hi guys
there seems to be plenty of info about best cheapo and value for money showers on here but what about more the top end what would you recommend? Pref to work of combi boiler, Oh and not just in ease of fitment but the best as in looks, ease of use and performance, Any idea's especially...
Can anyone point me in the right direction. I am looking for a therostatic mixer shower to run of a combi but i wont be able to bury the pipework so will have to run the pipework along the wall into the mixer bar. Have not looked yet thought it easier just to ask on the forum. cheers
Sure, ad-blocking software does a great job at blocking ads, but it also blocks useful features of our website. For the best site experience please disable your AdBlocker.