Search the forum,

blowing

Nose-blowing, or blowing your nose, is the act of expelling nasal mucus by exhaling forcefully through the nose. This is usually done into a facial tissue or handkerchief, facial tissues being more hygienic as they are disposed of after each use while handkerchiefs are softer, environmentally-friendly, can be reused after washing and after more stylish. However handkerchiefs have become unpopular due to their unhygienic nature but are often better than sneezing into hands or clothes.
Nose-blowing may be used to alleviate nasal congestion or rhinorrhea (runny nose) resulting from colds, seasonal allergies, or to expel nasal irritants.

View More On Wikipedia.org
Recent contents Top users
  1. M

    Baxi 50 HE Plus PCB fuse blowing

    Fuse blew on my Baxi and also the replacement. I don't touch gas but thought I would check visually. Condensate trap a bit mucky so drained anyway. Disconnected all the electrical leads -fan, gas valve, pump etc Hoping to identify the problem by trial and error i.e. reconnect until I get a...
  2. A

    Sime combi fuse keeps blowing

    Went to this boiler yesterday, 240 at the board coming in. 2amp fuse had blown. replaced the fuse, it blew again the second we switched it on. Back there tomorrow with a load of 2 amp fuses and have a new pcb just in case. I have been advised to unplug the different components until the...
  3. I

    New Boiler Blowing Up

    Installed a new boiler last week, which after 5minutes of being switched on blew up in my face. (I certainly would not wish this to happen to others) It wrecked my good looks lol smashed my nose, 2 black eyes and bruised arms and sent me flying across the kitchen. At this stage I'm not prepared...
    • Ivor Bates
    • Thread
    • blowing boiler happened ignition manufacturer model new boiler oil
    • Replies: 4
    • Forum: Plumbing Jobs | The Job-board
  4. B

    Ferroli DOMIcompact F24B - Both fuses blowing on PCB ??

    Hi All Recently purchased a flat and i know the boiler has not been used for months as the place was unoccupied. It does power up for a few second then BOTH fuses blow on the PCB, the display shows '7' when the power is on. Could this be something simple like a stuck CH pump (Grundfoss) or...
  5. F

    Vaillant turbomax plus 828e blowing fuse.

    Hello guys, I've the same issue with turbomax plus in two different properties. Basically costumers left the boiler off while they been away for few days, they've come back , turned the boiler on and the boiler keeps blowing fuses on the PCB. Has anyone come across this before? Cheers
  6. M

    wet vac blowing as well as sucking

    Evening all. I've got the wickes wet vac and when I use it to suck up water, it's blowing it strait out the blow side and on the customers carpet. Has this happened to any of you guys and could you fix it? Thanks, Mitchell.
  7. B

    Blowing Box :-)

    Not sure if this has been asked before but would like some advice for a tool box... My boss uses an old washing up bowl that He keeps his superfire 2, flux, steel wool, solder, pipe slices, mini pipe benders, bender guides, few other bits in. He has had the same one for the last 5 years. I have...
  8. M

    Trap blowing

    What causes a trap to blow back? I have got to look at a shower trap that is blowing water up out of it when the toilet is flushed. Any ideas?
  9. M

    conex fitting keeps blowing

    hi guys just been called to fix a leak which i have fixed twice already and has apparently been fixed several times in past. It is a hot water tee originally a john guest speed fit tee linking 2 copper 1 plastic. The tee itself had a gouge in on 1st visit. replaced with a conex tee. 4 days later...
  10. J

    why does the prd on trition shower keep blowing out?

    Hi, Replaced a worn out trition 300ti shower for a trition belize shower 6 weeks ago and after 3 weeks i got a call saying the pressure relief device has operated. I replaced the pressure relief device and it has lasted another 3 weeks untill i've had another call today informing me that it's...
  11. P

    Main Boiler Blowing out !

    Hi guys i have a main boile blowing out after about a minute, checked the fan, pressure switch fine, thinin its an ionisation problem, how do you check for ionisation?
  12. B

    Problems with Potterton Puma 100e Boiler - fuse keeps blowing please help!

    Hi, I would be grateful for any help or advice anyone can give me! I have a Potterton Puma 100e boiler and the 2 amp fuse on it keeps blowing. i have tried replacing the fuse twice and when I put the new fuse in the red light comes on however when I turn the tap on to get hot water the fuse...
    • Billyf100
    • Thread
    • blowing boiler could fuse help keeps oil please potterton problems water
    • Replies: 4
    • Forum: Plumbing Jobs | The Job-board
  13. P

    Back Boiler blowing fuse hot water only

    Hello, I have an annoying problem with a back boiler and struggling to get to the bottom of it. Moved in to a rented house 6 months ago that has a Potterton Fireside 35/51 back boiler. Over the last month found that when heating hot water only the 3 amp fuse blows in the socket. It is...
    • paulcantfixit
    • Thread
    • back boiler blowing boiler central heating system fuse hot hot water oil programmer system water
    • Replies: 29
    • Forum: Plumbing Jobs | The Job-board
  14. galaxy_plumbing

    Tribune Premier TP180e blowing fuses

    Hi guys, went to this water heater today. It started blowing fuses. I tested both elements for short circuit and found that top one had short circuit between live and neutral. I managed to get new element from merchant. After all the hassle when I try to remove old one I was happy to install...
  15. S

    Fuse Blowing - Jaguar Combi Bolier

    Hi guys. Hope you can help with this little problem. I was asked to have a look at a fault on a Jaguar wall hung combi boiler. There are two fuses on the PCB. One is 1.6A and the other is 80mA. The 80mA fuse is blowing intermittantly for no apparent reason and there is no pattern or associated...
  16. B

    poor work

    went to look at a job today old lady said her new boiler was dripping water and this is what i was faced with.i know on terrace houses siting the flue can be a pain but there is no excuse for this.i hate fitting the flue in a position like this even if its over 300mm away incase the wind blows...
  17. C

    Alpha CB33 Fuse blowing

    Hi Just had a confusing chat with Alpha Technical dept, the internal fuse was blowing on initial start up, we suspected the fan and determined that was the fault, fan changed and then the fan runs ok but again the fuse blows, points me to the air/pressure switch, one the fan has proved its...
  18. T

    dip tube bend

    Just wondering what the function of the dip tube bend is on the o/f fitting in a bye law 30 kit? cheers
  19. B

    Glow worm 18hxi boiler keeps blowing fuse

    I have the worlds worst boiler! We have spent over £800 on the boiler in the last 2 years and it is only 5 years old! Anyway now the latest issue is the following. It stopped and flashed up f13 which is related to the PCB. I took opened up the PCB and checked all connections. All were fine so I...
    • benver
    • Thread
    • again blowing boiler fuse glow glow worm glow-worm keeps oil reset worm years
    • Replies: 2
    • Forum: Plumbing Jobs | The Job-board
  20. D

    baxi barcelona control pcb keeps blowing fuse

    Hi, has any one came across this fault before? i am thinking of replacing the board but dont want the new one blowing cause the fans faulty or something. It has blown 3 fuses as soon as the power is turned on.
Creating content since 2001. Untold Media.

Newest Plumbing Threads

Back
Top
AdBlock Detected

We get it, advertisements are annoying!

Sure, ad-blocking software does a great job at blocking ads, but it also blocks useful features of our website. For the best site experience please disable your AdBlocker.

I've Disabled AdBlock