Speed fit tap connectors

[Mgrant]

Can I ask people thoughts on speedfit tap connectors they are ment to only need to be hand tightened. Getting less and less keen on fibre washer connections on taps and toilet fill valves now. Rubber washers seem to seal so much better.

 

[townfanjon]

I love them mate , used them for years , strong hand to tighten and they are fine

 

[Old Account]

I think the rubber connections are definitely better than fibre but don’t like the idea of pushfit. If pushfit then hep2o

 

[Chester]

work well, used them for a while and they make life just that bit easier never had a problem with them leaking.

 

[turnpin]

Must admit a favorite of mine as well great on plastic inlet valves on cistern regards Turnpin

 

[Best]

I don’t use the plastic fittings and tbh I just remove them (if add ons) where I have to replace a cistern or taps for examples.
I use soldered tap connectors, but I replace the fibre washers with the Hep flat rubber washers.

 

[Old Account]

I don’t use the plastic fittings and tbh I just remove them (if add ons) where I have to replace a cistern or taps for examples.
I use soldered tap connectors, but I replace the fibre washers with the Hep flat rubber washers.

That’s also a good so solution with being rubber washer I think by the time our solder all together isn’t it quicker to use the other fitting? I didn’t come across one which was leaking due to low quality materials if it’s leaked then due to not tighten it

 

[Best]

That’s also a good so solution with being rubber washer I think by the time our solder all together isn’t it quicker to use the other fitting? I didn’t come across one which was leaking due to low quality materials if it’s leaked then due to not tighten it

Yes definitely can’t beat the speed to install a Speedfit tap connector - 2 seconds compared with a couple minutes to have a copper tap fitting prepared and soldered plus then the time to tighten it up.
I haven’t seen a Speedfit tap fitting leaking yet, but they are delicate.
I know that on copper plumbing a lot of plumbers prefer to use a Speedfit connection to toilet cisterns.
I shall remain old fashioned though

 

[Mgrant]

Thanks tried a hep2O flat rubber washer on a copper 62. Seems a good fit. Just to confirm as tight as can with hand only on the speed fit connectors?

 

[Jim Goodenough]

Just to confirm as tight as can with hand only on the speed fit connectors?

yep that's it mate - you won't go wrong