Thermostatic radiator valves fitted correctly ?

[nodrog]

Hi I am a new member.

I am looking for some advice on whether some thermostatic radiator valves have been fitted correctly.

As part of a loft conversion the plumber fitted new radiators with thermostatic valves. I expected them all to be fitted on the inlet to the radiator, but I found that two were on the inlet and two were on the outlet. I found some instructions that were ambiguous but which seemed to suggest that the valves should be fitted on the inlet.

The plumber says there is no problem, but I have a feeling they should all have been fitted on the inlet side. Can anyone advise me what to look out for in the operation of a thermostatic valve incorrectly installed on the outlet i.e. would the valve fail to operate or operate poorly or what ?

Thanks in advance and apologies if this is question that someone has already asked.

 

[Dotty]

What trv's? Some are bidirectional......

 

[jase158]

TRV's sense the temperature of the air around them, so as long as they are bidirectional (water is allowed to flow both ways through it) and they are not covered by furniture/ curtains, they will work on either side. They do not need to be on the flow side.

 

[Ray Stafford]

Is there a specific problem with the performance of the system, or is this just a theoretical enquiry?

 

[Killy Bing]

Will humour you. Upload a photo of the trv.

 

[albatross]

It should not matter with modern valves.

 

[Ray Stafford]

It should not matter with modern valves.

No, it shouldn't. However, there are a couple of supposedly "bidirectional" TRVs on the market that under certain circumstances, will er... misbehave.

However, if the OP has that problem, I would have expected him to mention is - the symptoms are rather noticeable.

 

[fogarty]

No, it shouldn't. However, there are a couple of supposedly "bidirectional" TRVs on the market that under certain circumstances, will er... misbehave.

However, if the OP has that problem, I would have expected him to mention is - the symptoms are rather noticeable.

Give us a clue Ray .it might come in handy toro.

 

[Ray Stafford]

Give us a clue Ray .it might come in handy toro.

I think I have mentioned it in the Arms before Fogarty, but wouldn't want to name brand names in the open forum.

 

[smtplumbing]

danfoss valves are ment to be fitted on the return but no one ever fits them that way

 

[Ermintrude]

Any valve for less than £6 with lock shield probably gash . Unless it's the bulldogs !

Always fit trv so it gets best exposure to room temp.

 

[Killy Bing]

danfoss valves are ment to be fitted on the return but no one ever fits them that way

Just turn the internal ring to change flow direction

 

[anz]

Any valve for less than £6 with lock shield probably gash . Unless it's the bulldogs !

Always fit trv so it gets best exposure to room temp.

I've had a few problems with the Bulldogs, they seem to last about just under a year before the heads start failing. I don't fit them anymore.

 

[smtplumbing]

i was on the danfoss course and that what the boy said should be on the return if i can be assed i upload the doc

 

[Killy Bing]

i was on the danfoss course and that what the boy said should be on the return if i can be assed i upload the doc

All the domestic stuff is bi directional with a flow direction changing ring.
commercial stuff goes on the return though.