Search the forum,

Discuss One for the electricians amongst you. in the General Off-Topic Chat area at PlumbersForums.net

gmartine

Esteemed
Gas Engineer
Messages
2,340
If I wanted to run a few domestic sockets or even a whole ring main (seperated from CU of course) from my generator and do so safely with regards to electronic devices what device or kit should or could I use inline to make it a safe supply?
 
What kinds of gen set is it ?
 
The problem comes when you try and run sensitive electronics off the inverter for best results you need a pure signwave model
 
I thought a generator inverter was for sensitive kit, I had a look through some posts on the electricians forum and the most relevant post I found suggested not to worry about it cos most electronic items like laptops had resilient PSUs.
 

Reply to One for the electricians amongst you. in the General Off-Topic Chat area at PlumbersForums.net

Similar plumbing topics

Hi all. Hope you have all been keeping well. A while back I decided I only wanted to fit one brand of boiler and decided on Viessmann due to space for servicing and changing parts if ever needing to. I am finding my decision rather hard due to the different clearances on flue runs and cupboards...
Replies
9
Views
227
The fittings below are for a mixer bar attached to a self contained shower. i.e not a wall. The attaching screws have snapped. I could get two new brackets, dismantle that existing one and start again or I could try and re attach via those screws, removing the broken ones from the plate and wall...
Replies
1
Views
219
I want to reconnect some outbuildings to an existing water supply. The supply pipe is old 22mm MDPE and buried for a fair distance so not going to dig it up and replace it šŸ˜¬. Question is can I use normal 22mm plumbing push-fit connectors to make the connection as finding 22mm MDPE fittings...
Replies
1
Views
289
S
Hi, I seemed to have a blockage in kitchen sink. A plumber came and cleared all the pipework that is visible inside my home (there was debris and pebbles!) We saw that the pipe that takes water down the gutter was visibly full to the top. He said he will return with a coil to push through...
Replies
2
Views
113
S
Hello all, I'm would like to extend an existing outside tap to another point in the garden. I'm about to pour a concrete patio and was hoping to run the water line underneath. There are existing drain (and who knows what) pipes running along the same wall so I'm nervous about digging too far...
Replies
6
Views
244
Creating content since 2001. Untold Media.

Newest Plumbing Threads

Back
Top
AdBlock Detected

We get it, advertisements are annoying!

Sure, ad-blocking software does a great job at blocking ads, but it also blocks useful features of our website. For the best site experience please disable your AdBlocker.

I've Disabled AdBlock