Search the forum,

Discuss Are these pipes acceptable? in the DIY Plumbing Forum area at PlumbersForums.net

Messages
3
We had a leak from our boiler which meant I had to take up the flooring. This was a bathroom, but we want a utility room, so will be putting in the washing machine. I don't know if these pipes are accetable though? We need the water feed (on the left) and the pipe for the waste (you can see on the right curving behind the boiler pipes). The waste pipe is 22mm OD.
This is part of an extension at the front of the house built by a prevous owner, the pipes dissappear under what used to be the external wall.
 

Attachments

  • IMG_20210303_124541.jpg
    IMG_20210303_124541.jpg
    422.6 KB · Views: 43
They look fine would clean all the rubbish out under the floor tho
 
They look fine would clean all the rubbish out under the floor tho

I never really thought about this but can I pick your brain.

If I hadn’t read your post, I would have advised against connecting a washing machine discharge to an overflow pipe.

Wouldn’t the increase in friction of the overflow pipe compared to 1.5 inch waste, cause issues with the washing machine pump?
 
It’s one of them bigger always better but if it’s only a short run it should be fine and it looks like one was connected there before left hand side washing machine point
 
It’s one of them bigger always better but if it’s only a short run it should be fine and it looks like one was connected there before left hand side washing machine point
Well, i'm not sure if it is a short run. I'm not sure where they go once under the wall. The kitchen and bathroom are at the back of the house, as are the drains I believe. Thats 10m back and 5m across.
 
Where does the boiler condense go into ?
 
We had a leak from our boiler which meant I had to take up the flooring. This was a bathroom, but we want a utility room, so will be putting in the washing machine.
I don't like the look of the the way the ends of the joists are being supported. The piece running left to right looks undersized to me and I can't see where the load is being transmitted to. If you put a washing machine there the joists are going to get a regular thumping during the spin cycles.
 

Reply to Are these pipes acceptable? in the DIY Plumbing Forum area at PlumbersForums.net

Similar plumbing topics

Hello all, I’m replacing a concrete paving slab patio in the back yard. The original patio used 50mm deep concrete slabs on hardcore & sand. I’m...
Replies
6
Views
296
I was stupid enough not to check the position of the pipes under the tiles when installing a toilet and drilled right through the center of a 16...
Replies
0
Views
224
Copper pipes, I think its fair to say, is not what it used to be, the copper is getting thin while the cost is going up. Meanwhile, plastic...
Replies
2
Views
296
Creating content since 2001. Untold Media.

Newest Plumbing Threads

Back
Top
AdBlock Detected

We get it, advertisements are annoying!

Sure, ad-blocking software does a great job at blocking ads, but it also blocks useful features of our website. For the best site experience please disable your AdBlocker.

I've Disabled AdBlock